Radio Shack 23-437 owner manual 124#6+10, +/2146#065#6 +05647%6+105, #4+0###0 ###$#664+5

1XGTPKIJV"%JCTIGT"HQT"##1###1;8"0K/%F"QT"0K//*"$CVVGTKGU

23-437 OWNER’S MANUAL — Please read before using this equipment.

#"+/2146#06"#

If an icon appears at the end of a paragraph, go to the box on that page with the corresponding icon for pertinent information.

Rý— Warning	° — Hint
. — Caution	± — Note
# — Important

Thank you for purchasing the RadioShack Overnight Charger for AA/AAA/9V Ni-Cd or Ni-MH Batteries. Your charger is designed to charge two or four AA or AAA batteries, or one 9V battery.

Its features include:

Two Charging Indicators — FRONT or REAR lights when charging batteries in the front or rear charging bay and turns off when charging is complete.

Reverse Polarity Protection — protects the charger and batteries against damage from incorrectly installed batteries.

Automatic Timer Shut-Off — turns off the charger to prevent overcharging AA or AAA batteries.

Your charger is ETL listed to UL standards.

12'4#6+10

%*#4)+0)"##"#0&

###"$#66'4+'5

Ni-Cd/

Ni-MH

FRONT	REAR
Indicator	Indicator

+/2146#06"5#('6;" +05647%6+105

Charging Bay

Tab

."%#76+10".

Do not mix battery types (Ni-Cd and Ni-MH).

±"016'"±"

•Both batteries must be installed in the same bay.

•It is normal for the batteries to become warm while charging.

•Charge the batteries in an area with temperatures between 32 and 113° F (0–45° C). If the area is too cold, the batteries can permanently lose their ability to charge. If the area is too warm, the batteries will not fully charge.

•Do not try to charge batteries other than those listed in this manual, or use procedures other than those described in this manual.

•You cannot charge AA batteries in one bay and AAA batteries in the other bay at the same time.

SAVE THESE

INSTRUCTIONS!

This manual contains important safety and operation instructions for your battery charger. Before using your charger, read all instructions and cautionary markings on the charger, the batteries to be charged, and the product that uses the batteries.

Warnings:

•Charge only Ni-Cd or Ni-MH batteries with this charger. Other types of batteries might burst, causing personal injury.

•Do not disassemble the charger; take it to a qualified service technician when service or repair is required. Improper reassembly may result in a risk of electric shock or fire.

•Do not use an attachment not recommended or sold by RadioShack as this could result in a risk of fire, electric shock, or injury.

Cautions:

•Do not expose the charger to rain or excessive moisture.

•Do not operate the charger if it has received a sharp blow, or been dropped or damaged in any way. Take it to a qualified service technician for repair.

•Do not use an extension cord. Its use could result in fire or electric shock.

•Never use the charger as a DC power source for any electrical equipment.

1.Slide Ni-Cd/Ni-MHto the desired setting.

2.Adjust the charging bay for AA or AAA batteries.

The tab on the top of the front and rear charging bays let you adjust the battery holder for AA or AAA batteries. Pull down the tab to charge AAA batteries. Lift up the tab to charge AA batteries.

3.To charge two batteries, insert the batteries in the front or rear bay

according to the polarity symbols (+ and –) marked inside. .#±

To charge four batteries, insert the batteries in the front and rear charging bay according to the polarity symbols (+ and –) marked inside.

4.Lift the AC plug’s prongs, located on the rear of the charger, until they snap into place. Plug the charger into a standard AC outlet. FRONT lights when AA or AAA batteries are charging in the front bay. REAR lights when AA or AAA batteries are charging in the rear bay.

AC Plug

Tab

Charging

Bay

© 2002 RadioShack Corporation.

All Rights Reserved.

RadioShack and RadioShack.com are trademarks

used by RadioShack Corporation.