Radio Shack 26-184 owner manual 75$+056#..#6+10, Ctfyctg, 5QHVYCTG, 9KPFQYU, 556/437+4/065

8"(QQV"75$"VQ"2CTCNNGN"2TKPVGT"%CDNG

www.radioshack.com™

OWNER’S MANUAL —	26-184
Please read before using this equipment.

2#%-#)'"%106'065

•Installation driver in floppy diskette (for Windows 98, Windows 98SE and Windows ME. (The driver is pre-installed in Windows 2000, and Windows XP.)

•6 ft. USB to Parallel Printer Cable

•This Owner’s Manual

±"016'"±"

You cannot operate this printer cable with Windows 95.

USB (Universal Serial Bus)

Connector

Parallel Connector

Thank you for purchasing the RadioShack 6 ft. USB to Parallel Printer Cable. This printer cable lets you connect a printer with a traditional IEEE-1284 parallel interface to a USB (Universal Serial Bus) interface. This cable is compatible with most printers that have a 36-pin socket, and fully compatible with USB host device drivers. The cable uses single chip (ASIC) USB to parallel for full speed communication. It supports both true bi-directional communication, and standard PC parallel port register based operation. It is both USB Specification Rev.

1.1compliant and IEEE-1284 1994 (bi- directional parallel interface) specification compliant. Since the cable is powered by the USB port, it has a very low power consumption.

5;56'/"4'37+4'/'065

*CTFYCTG

Your computer must be an IBM PC-compatible with an Intel-compatible 486DX-66 MHz CPU or higher. It must have one standard 4-pin USB port with the symbol.

5QHVYCTG

Windows 98, Windows 98SE, Windows ME, Windows 2000, or Windows XP.±

75$"+056#..#6+10

1.Turn on your computer.

2.Make sure the USB port is enabled and works properly.

3.Plug the USB plug into the USB port.

Connectors are gold-plated to deliver the best signal possible.

Depending on which operating system you have, Windows will detect a USB device and the corresponding Wizard will be initiated.

9KPFQYU";:

Windows 98 detects the RadioShack USB to Parallel Printer Cable device and runs the Add New Hardware Wizard to help you installing the driver software for the printer.

1.Click Next to continue.

2.Insert the supplied USB to parallel printer cable driver diskette into the floppy disk drive.

3.Select Search for the best driver for your device (Recommended), and click Next to continue.

4.Select Floppy disk drives, and click Next to continue. Windows will detect the driver (A:\PARUPL.INF) and shows the RadioShack USB to Parallel Printer Cable device.

5.Click Next to continue installation.

6.When Windows reports it has finished installing the software required for the new RadioShack USB to Parallel Printer Cable device, click Finish.

9KPFQYU"/'

Windows ME detects the RadioShack USB to Parallel Printer Cable device and runs the Add New Hardware Wizard to help you installing the driver software for the printer.

1.Insert the supplied USB to parallel printer cable driver diskette into the floppy disk drive.

#"+/2146#06"#

If an icon appears at the end of a paragraph, go to the box on that page with the corresponding icon for pertinent information.

Rý— Warning # — Important ±— Note .— Caution ° — Hint

© 2002 RadioShack Corporation.

All Rights Reserved.

RadioShack and RadioShack.com are trademarks used by

RadioShack Corporation.