MOUNTING THE PHONE
USING THE PHONE
Desk Mounting | Wall Plate |
| Mounting |
Note: The adapter powers the phone’s neon light and is not needed for phone operation.
Cautions:
•Always unplug the adapter from the AC outlet before you unplug the other end from the phone.
•The supplied AC adapter supplies 12 volts, delivers at least 400 milliamps, and has a plug which properly fits the phone’s DC 12V jack. Using an adapter that does not meet these specifications could damage the phone or the adapter.
Wall Mounting | Handset Holder |
| If you mount the |
| phone on a wall, pull |
| out the handset holder |
| and rotate it 180°. |
| Handset Holder |
Note: The USOC number of the jack to be installed is RJ11C (RJ11W for a wall jack).
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
This symbol is intended to inform you that parts inside the telephone present a risk of electric shock.
Set to TONE or PULSE to match the type of service you have.
If you have pulse (rotary) service, you can set it to TONE (or press ) during a call to use tone services, such as
Hold down MUTE to talk with someone in the room without being heard by the person on the phone.
To resume your conversation, release MUTE.
Plug the handset cord into the jacks on the handset and base, as shown by the arrows above.
Press FLASH to produce a switchhook signal for special ser- vices such as call waiting.
Note: If you do not subscribe to any special services, pressing FLASH might disconnect the call.
Press REDIAL to dial the last number dialed (up to 31 digits).
Press to end a call without returning the handset to the cradle.
Use a paper clip or other pointed object to lift the plastic cover off the number plate. Then write your phone number and up to ten other important numbers on the number plate and replace the cover.
Note: Use a pencil so you can change the numbers later.
Press the switchhook to dis- connect a call.
Set the ringer to sound
ahigh- or
Set VOLUME to LO/MED/ HI to adjust the volume you hear through the handset.
Set NEON to ON to turn on the neon light, or set to OFF to turn it off.
With NEON set to ON, the neon light stays on when the phone is not in use, turns off when you pick up the handset, and flashes when the phone rings.
This symbol is intended to alert you to important operating and servicing in- structions included in the papers with the telephone.
©1998 Tandy Corporation. All Rights Reserved.
RadioShack is a registered trademark used by Tandy Corporation.