Radio Shack 61-2117 manual

Two Bell Wireless Door Chime

61-2117	OWNER’S MANUAL — Please read before using this equipment.

! IMPORTANT !

If an icon appears at the end of a paragraph, go to the box on that page with the corresponding icon for pertinent information.

o— Warning	Ó — Hint
— Caution	Ô — Note
! — Important

Receiver

Slide ON/OFF to ON so that when BELL is pressed on one of the transmitters, a door chime sounds.

Transmitter (two included)Indicator — Lights when BELL is pressed.BELL — Press BELL to hear the door chime.

CAUTION

•Use only fresh batteries of the required size and type. Always remove old or weak batteries. They can leak chemicals that destroy electronic circuits

•Do not mix old and new batteries, different types of batteries (standard, alkaline, or rechargeable), or rechargeable batteries of different capacities.

Thank you for purchasing the RadioShack Two Bell Wireless Door Chime. It works as a doorbell, a remote pager, or an alert. You can add an optional external sensor to have a chime that alerts you when someone walks into a room. The wireless door chime’s three-position channel switch prevents other transmitters or radio devices from sounding the chime.

MOUNTING THE

RECEIVER

ON A FLAT SURFACE

Pull out the wire stand on the back of the receiver and set it on a table or other flat surface.

ON A WALL

1.Drill one 3/16-inch diameter hole and insert one of the supplied anchors.

2.Drive the supplied M3.5 screw into the hole until the screw's head extends about 1/8 inch from the wall.

3.Align the keyhole slot on the bottom of the receiver with the screw in the wall, then slide it down to secure it.

MOUNTING THE

TRANSMITTER

1.Remove the transmitter from the holder.2.Use the holder as a template to mark two screw holes on the wall.

3.Remove the holder from the mounting surface and drill two 1/4 inch diameter holes. Insert one of the supplied anchors into each hole.

4.Drive a screw through the holders.

5.The transmitter can be slid in and out of the holder. To lock the transmitter in the holder, fix it with a size M2.6 screw at the bottom of the holder.

INSTALLING BATTERIES AND SELECTING CHANNELS

The wireless door chime requires three AAA size batteries in both transmitters and three C size batteries in the receiver. For best performance and longest life, we recommend RadioShack alkaline batteries.

IN THE TRANSMITTER

1.Slide the transmitter's battery compartment door in the direction of the arrow to remove it.

2.Use a small flat-blade screwdriver to slide the switch inside the battery compartment to the desired channel for the transmitter.

RadioShack and RadioShack.com are trademarks

used by RadioShack Corporation.