large display wireless indoor/outdoor thermometer
Thank you for purchasing your Large Display Wireless Indoor/Outdoor Thermometer from RadioShack. You can mount it on a wall or place it on a flat surface using the included stand. Your thermometer can collect and display indoor and outdoor temperature and humidity readings from up to three sensors, and forecast weather.
SNOOZE
The main unit requires three AA alkaline batteries and the remote sensor requires two AAA alkaline batteries for power. None are supplied; all are available at RadioShack or online at www.radioshack com.
NOTE | For best results, always install batteries |
| in the remote sensor first, and then in the |
| main unit. |
and Increase or decrease setting and activate or
1.Remove the battery compartment covers from the main unit and remote sensor, respectively. If you are using more than one sensor, select a different channel for each sensor by switching CHANNEL 1 2 3.
2.Place the appropriate batteries in each compartment, following the polarity symbols (+ and
3.Reset each unit and replace the battery compartment covers.
RESET
CHANNEL 1 2 3
RESET
Weather Forecast and Barometric Trend Area
Outdoor Temeprature and Humidity Area
Indoor Temperature and Humidity Area
Clock and Alarm Area
deactivate the Atomic Clock.
MODE
Use to change the display and settings.
((•))
Set alarm or view alarm status.
Turn alarm on or silence it for 24 hours.
CHANNEL
Switch remote sensors.
MEMORY
View current, maximum, and minimum temperature and humidity readings.
PRESSURE Change pressure measurement units.
°C/°F
Select temperature units.
on flat surfaces
Place the main unit indoors and the remote sensor outdoors. Place them on flat surfaces using their respective stands (included).
wall mounting
1.Select an indoor wall for your main unit and an outdoor wall for your remote sensor.
2.Remove the stands from the main unit and remote sensor, respectively.
2.Drill a hole in the wall.
3.Thread a screw (not supplied) into the hole, letting it extend about 3/16” from the wall.
4.Fit the head of the screw into the appropriate keyhole slot.
This clock shows the current time and the day of week in English, French, German, Italian, or Spanish. The US Atomic Clock in Boulder, Colorado, automatically updates the information when the main unit is within 932 miles of a signal. Initial reception takes
1.Press and hold MODE for 2 seconds. The time zone blinks.
2.Press MODE to select the time zone, hour,
minute, year, month, day, and language. Press or to set your desired setting. Press
MODE to confirm.
• The language options are E (English),
NOTE | F (French), D (German), I (Italian), and |
|
S (Spanish). |
• The time zone options are PA (Pacific), |
CE (Central), MO (Mountain), and EA (Eastern). |
Keyhole
Slot
Stand
setting your alarm
This product is equipped with a
1.Press ((•)) to switch to the alarm display.
2.Press and hold ((•)) again for 2 seconds. The alarm hour digits blink.
3.Press UP or DOWN to change settings. Press ((•)) to confirm.
activating your alarm
Press to activate or deactivate the alarm. shows in the clock and alarm area when the alarm is activated.
silencing your alarm
When the alarm sounds, it will continue for 2 minutes. Press SNOOZE to silence it for 8 minutes. Or, press to turn it off until the next day.
Please read this user’s guide before | main unit and stand | remote sensor |
user’s guide | wire stand | |
installing, setting up and using your new product. |
|
|
www.radioshack.com |
|
|
• Press MODE to toggle between Clock with |
Seconds and Clock with Weekday display. |
If no button is pressed, the alarm will automatically silence after 2 minutes. It will then sound again after 8 minutes.
