Wrist Cuff Blood Pressure Monitor
Step One
Install Batteries
1.Remove the battery compartment cover.
2.Insert two AAA batteries as indicated by the polarity symbols. For easy removal, place the ribbon under both batteries.
3. Replace the cover.
When the display dims or batteries weaken, Áappears on the display. Replace the batter-
ies.
Step Two
Setting the Date and Time
1.Press MODE. The month digit flashes.
2.Repeatedly press (or hold down) SET to set the correct month.
3.Repeat Steps 1 and 2 to set the date, hour, and minute. Press MODE when finished.
What’s Included
• | Wrist Cuff | • | Storage Case |
•Monitor
Step Three
Attaching the Pressure Cuff
1.With your palm face up, wrap the pressure cuff snugly around your wrist, leaving about 3/16 inches to 13/32 inches (0.5 to 1 cm) clearance between the wrist and the cuff.
2.Place your elbow on the table and wrist against the armrest or the storage case so the pressure cuff is at the same height as your heart.
Step Four
Measuring Blood Pressure
1.Press START/STOP. All display segments appear briefly, the systolic rate rests to 00, and Âappears. The pressure cuff
automatically inflates to 195 mmHg or the sufficient pressure level for measurement. The systolic rate varies, and ♥ flashes at the same rate as your heartbeat.
2.Once the monitor detects your blood pressure reading, the pressure cuff deflates slowly. Your blood pressure reading and pulse rate appear.
3.To stop measurement, press START/STOP.
Ãappears for about five seconds when:
•The pressure cuff is not wrapped around your wrist correctly.
•You move or talk during measurement.
•You do not have correct posture.
Step Five
Recalling Stored Readings
1.Press RECALL. The last reading with the date and time appears.
2.Repeatedly press (or hold down) RECALL to view other stored readings (up to 48).
3.To view current date and time, repeatedly press or hold down RECALL until the current date and time appear.
4.To erase all stored readings, remove and reinstall the batteries.