Radio Shack 63-1525 manual

Body Fat Analyzer

63-1525

Step One

Installing the Battery

Your body fat analyzer comes with one CR 2032 button cell battery (uninstalled).

(/) - lets you select and enter information.

Large Display - shows your body fat percentage and body fat type.Grip Pads - grip these to take a measurement.

What’s Included

Body Fat Analyzer One CR 2032 BatteryOwner’s Manual

Important

Do not use the analyzer if you are pregnant, have a pacemaker implanted in your body, or are on an electronic life support system. The measurements made by the analyzer are for personal reference only. Consult your doctor for more information about body fat. It is best to use the same body fat analyzer during your training in order to receive consistent readings. Readings may vary among other body fat analyzers.

1.Slide off the cover.2.Insert the battery, with the positive (+) side up. kg/cm flashes.3.Replace the cover.

If the analyzer turns off after you install the battery, press º to turn it on and make sure

the measurement unit (kg/cm or

lb/ft/in) youwant to display appears.

If you do not want to store a reading when kg/cm flashes, press S and then º to turn off the analyzer. Otherwise, kg/cm continues to flash and consume battery power.

Step Two

Removing the Protective Plastic

The display is protected by a piece of clear plastic. Peel off the plastic before using your analyzer.

Step Three

Storing a Personal Profile

Your analyzer stores up to eight personal profiles, letting you enter and save information for up to eight people. You can also enter a temporary profile, which the analyzer does not save.

1. Select a measurement unit by	2. Repeatedly press ( or ) to select	3. Repeatedly press ( or ) until
repeatedly pressing (or ) while	the desired profile number. Then hold	your weight appears, then press S.
kg/cm (kilograms/centimeters) or	down S until 110 lb or 50 kg (the	Repeat these steps to store your
lb/ft/in flashes. Then press S.	default weight setting) flashes.	height, age, and gender.

If you want to change the measurement unit, remove the battery. Hold down S and reinstall the battery synchronously. Then, repeat these steps.

To enter a profile, but not store it in the analyzer, select 0 as the desired profile number in Step 2. If you do not press any key for about one minute, the analyzer automatically turns off.

Body Fat Types

Underweight	Healthy	Slightly	Overweight	Obese
		Overweight