Radio Shack 63-984 user service Mounting the Receiver

63-984.fm Page 4 Wednesday, September 8, 1999 4:42 PM

low). Then insert an anchor into each hole.

3/16 Inch Diameter Hole

50mm

85mm

2.Align the metal mounting bracket with the holes you just drilled and drive a screw through the bracket into each hole. Do not overtighten the screws.

3.Align the slot on the back of the transmitter with the hook on the mounting bracket. Carefully push the transmitter onto the hook and slide it down to secure it.

4.Once the transmitter is securely on the bracket, insert the two supplied pan-head machine screws through the two holes on the lower edge of the transmitter and into the threaded holes in the bracket.

Mounting the Receiver

To mount the receiver onto a typical sheetrock wall, use the two supplied pan washer screws and anchors. Other- wise, consult your local hardware store for suitable hardware.

1.Drill two 3/16-inch diameter holes into the mounting surface about 43/16 inches (106 mm) apart

2.Insert an anchor into each drilled hole, then thread a screw into each anchor, letting the head of each screw extend about 1/8 inch from the wall.

1/8 Inch

4