USING THE PHONE

This symbol is intended to inform you
that parts inside the telephone present
a risk of electric shock.
This symbol is intended to alert you to
important operating and servicing
instructions included in the papers with
the telephone.
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
Note: The USOC number of the jack to be installed is
RJ11C.

MOUNTING THE PHONE

You must mount the phone on a wall mount plate. If you
do not have a wall mount plate, you can find one at your
local RadioShack store.
1. 2.
3.
Back of
Phone
Place the keyhole slots
over the wall mount
plate’s studs as you plug
the phone’s connector
into the jack. Then slide
down the phone to se-
cure it.
Slide in the lock lever.
Slide out the lock lever
on the back of the phone.
Note: The connector
slides up as you slide the
phone down so the con-
nection is not broken.
Switch to T (Tone) or P (Pulse) to
match the type of service you
have. If you have pulse (rotary)
service, you can switch to T dur-
ing a call to use tone services.
Press REDIAL to dial the
last number dialed (up to
32 digits).
Press and hold down to
disconnect a call. Press
and release for special
services such as Call
Waiting.
Plug the handset cord into
the jacks on the handset
and base.
Adjust the handset volume to a
comfortable listening level — LO
(Low), MED (Medium), or HI
(High).
Set the ringer for a
high- or low-volume
ring, or turn off the
ringer. You can make
calls with the ringer
off, and you can
receive calls if you
hear another phone
on the same line
ringing.
Note: If you do not
subscribe to any
special services,
pressing the switch-
hook might discon-
nect the call.
Press for special services.
Write your phone number
on the phone number card.
© 1999 Tandy Corporation.
All Rights Reserved.
RadioShack is a registered trademark used by Tandy Corporation.