Radio Shack ET-212 owner manual Set Up, Using the Phone, STORING/DIALING Numbers in Memory

SET UP

Plug the coiled handset cord into the jacks on the hand- set and base.

Plug one end of the supplied long telephone line cord into the jack on the back of the base. Plug the other end into a modular phone jack.

Illustration

As shown below, attach the mounting bracket based on how you are mounting the phone.

Illustration

If you mount the phone on the wall, press up on the handset cradle hook to remove it. Then turn it over so its tabbed edge faces up and press it back down into its slot.

Illustration

Note: The USOC number of the jack to be installed is RJ11C (RJ11W for a wall plate jack).

CAUTION

USING THE PHONE

Handset cradle hook holds	Press the switchhook to	Press STORE once before and after you
handset in place when phone	disconnect a call.	enter the phone number you want to store.
is wall mounted. Use this hook		See “Storing/Dialing Numbers in Memory.”
to hold the handset temporarily
without disconnecting a call.		Set to TONE or PULSE to match
		the type of service you have. If
		you have pulse service, you can
		move it to TONE (or press	)
		during a call to use tone ser-
		vices, such bank-by-phone.
Set to LOW, MED, or HI to
adjust the handset volume		Set RINGER to 1, 2, or 3 to adjust
to a comfortable listening
		the ringer’s tone.
level.
		Slide RINGER VOL. to adjust the
		ringer volume to a comfortable
		level.

Press FLASH instead of the	Press REDIAL to dial the last
switchhook for special services	number dialed (up to 32 digits).
such as Call Waiting.
	Indicator lights when the handset is
	off the hook.

STORING/DIALING NUMBERS IN MEMORY

To store a number in memory:		To dial a number in memory:
1.	Lift the handset and press STORE.	1.	Lift the handset.
2.	Enter the telephone number you want to store (up	2.	Press P1, P2, or P3.
	to 16 digits).

RISK OF ELECTRIC SHOCK

DO NOT OPEN

This symbol is intended to alert you that parts inside the telephone present a risk of electric shock. Do not open the case.

Note: To enter a pause of about 4 seconds to access a second dial tone, press REDIAL. Each pause entry counts as one digit in memory.

3.Press STORE again.

4.Press P1, P2, or P3, then return the handset to the cradle.

Note: If you store an emergency service’s number (po- lice, fire department, ambulance) and you want to test the stored number, make the test call during the late evening or early morning hours to avoid peak demand periods. Also, remain on the line to explain the reason for your call.

This symbol is intended to alert you to important operating and servicing instructions included in the papers with the telephone.

ã1998 TandyÐÐCorporation. All Rights Reserved.

RadioShack is a registered trademark used by Tandy Corporation.