SET UP
Plug the handset cord into the jacks on the handset and base.
Plug one end of the supplied long telephone cord into the jack on the back of the base. Plug the other end into a modular phone jack.
Attach the mounting bracket as shown.
If you mount the phone on the wall, press up on the hand- set cradle hook to remove it. Then turn it over so its tabbed edge faces up, and press it back down into its slot.
USING THE PHONE
Press the switchhook to | Use this holder to hold the handset |
disconnect a call. | temporarily without disconnecting |
| a call. |
Handset Cradle Hook |
|
Set the switch to LO, MED, |
|
or HI to adjust the handset |
|
volume to a comfortable |
|
listening level. |
|
Press REDIAL to dial the last number dialed (up to 32 digits).
Press 
to temporarily switch to tone dialing when using pulse service.
Press STORE once to enter the phone number you want to store. See “Storing/ Dialing Numbers in Memory.”
Switch to TONE or PULSE to match the type of service you have.
Set the ringer switch to HI in a noisy room or LO in a quiet room. To turn off the ringer, set it to OFF. You can still make calls with the ringer off and you can also receive calls if you hear another phone on the same line ring.
Slide VOLUME to adjust the speakerphone volume to a comfortable listening level.
Lights when you are using the speakerphone.
Press to activate the speakerphone for hands- free conversation or on- hook dialing.
STORING/DIALING NUMBERS IN MEMORY
Note: The phone company charges to install any neces- sary jacks. The USOC number of the jack to be installed is RJ11C (or RJ11W for a wall mount).
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
This symbol is intended to alert you that parts inside the telephone present a risk of electric shock. Do not open the case.
To store a number into memory:
1.Lift the handset (or press SPEAKERPHONE) and press STORE.
2.Enter the telephone number you want to store (up to 16 digits).
3.Press P1, P2, or P3 to store the number into that memory location, then return the handset to the cra- dle (or press SPEAKERPHONE) .
To dial a number in memory:
1.Lift the handset (or press SPEAKERPHONE).
2.Press P1, P2, or P3.
Note: If you store an emergency service’s number (po- lice, fire department, ambulance) and you want to test the stored number, make the test call during the late evening or early morning hours to avoid peak demand periods. Remain on the line to explain the reason for your call.
This symbol is intended to alert you to important operating and servicing instructions included in the papers with the telephone.
©1997 Tandy Corporation. All Rights Reserved.
RadioShack is a registered trademark used by Tandy Corporation.
