Radio Shack PLCD34 instruction manual Trouble Shooting

Models: PLCD34

1 6
Download 6 pages 63.65 Kb
Page 5
Image 5

TROUBLE SHOOTING

Before going through the check list, wiring connection, should any of the problem persist after check list has been made, consult your nearest service dealer.

Symptom

Cause

Solution

 

 

 

 

The car ignition is not on.

If the power supply is properly

No power

 

connected to the car accessory

 

switch the ignition key to " ACC "

 

 

 

 

 

 

The fuse is blown

Replace the fuse

 

 

 

Disc cannot

Presence of CD disc inside

Remove the disc in the player

the player

then put a new upward

be loaded or

 

 

Inserting the disc in upside

Insert the compact disc with

ejected

 

down

the label facing upward

 

 

 

 

Compact disc is extremely

Clean the disc or try to play a

 

dirty or defective

new one

 

 

 

 

Temperature inside the

Cool off until the ambient

 

car is too high

temperature returns to normal

 

 

 

 

Condensation

Leave the player off for an

 

 

hour or so, then try again

 

 

 

No sound

Volume is in minimum

Adjust volume to a desired level

 

 

 

Wiring is not properly

Check wiring connection

 

connected

 

 

 

 

 

The operation

The built-in microcomputer

Press the RESET button

keys do not

is not operating properly

front panel is not properly

work

due to noise

fix into its place

 

 

 

Sound skips

The installation angle

Adjust the installation angle

is more than 30 degrees

to less than 30 degrees

 

 

 

 

 

The disc is extremely

Clean the compact disc/try to

 

dirty or defective

play a new one

 

 

 

The radio does

 

 

not work

The antenna cable is not

Insert the antenna cable firmly

the radio

connected

 

station

the signals are too weak

select a station manually

automatic

 

 

selection does

 

 

not work

 

 

 

 

 

BALANCE CONTROL

1). Press the SEL button to select the balance mode until BAL appears on LCD.

2). Press the + button or - button to increase or decrease the sound level of left or right speaker.

FADER CONTROL

1). Press the SEL button to select the fader mode until FAD appears on LCD.

2). Press the + button or - button to increase or decrease the sound level of front or rear speaker.

2. OPEN BUTTON

Press it to flip down the front panel when you want to take away. Press it to flip down the front panel then you can insert a disc into the slot or eject a disc from the slot by pressing the EJ button which located the back of the panel.

3.LOUD( LOUDNESS) BUTTON

Press "LOUD" to enhance the bass sound effect while reduce the volume half level .

4.DSP( DISPLAY) BUTTON

Press it to apply these function, and press it continually to switch between 4 preset equalizer curves: FLAT POP, CLAS, ROCK.

And the sound quality will be accordingly changed. (FLAT IS INITIAL DEFAULT)

5.CLOCK ADJUSTMENT BUTTONS

During RADIO or CD state, press this button to change to clock function. Hold this button for more than 2 seconds until the time flashes on LCD, then you can adjust Hours and Minutes by pressing UP and DN button. After adjustment, press this button to resume normal play state and remain the adjustment.

6.LCD ( LIQUID CRYSTAL DISPLAY)

7

4

Page 5
Image 5
Radio Shack PLCD34 instruction manual Trouble Shooting