Radio Shack XL-260 owner manual ˆConnecting Inputs, Low-Levelinputs

12-2017.fm Page 8 Tuesday, May 9, 2000 10:02 AM

6.Use a screwdriver to connect the spade end of the supplied red power cable (with in-line fuse holder) to the ampli- fier’s + 12V terminal.

7.Connect the other end of the red power cable to your vehicle’s positive (+) bat- tery terminal as shown. Then tighten the terminal.

Caution: Due to the amplifier’s high cur- rent requirement, you must connect the red power cable’s fused end directly to the vehicle’s positive (+) battery terminal or damage to your vehicle’s wiring could result.

Do not reconnect your vehicle’s negative (–) battery cable yet.

ˆConnecting Inputs

LOW-LEVEL INPUTS

You can connect your auto sound system’s low-level line out jacks to the amplifier’s low- level line in jacks.

If your auto sound system does not have low-level line out jacks, see “High-Level (Speaker Wire) Inputs” on Page 9 to connect your amplifier.

Note: For the best results, use shielded au- dio cables (not supplied) available at your lo- cal RadioShack store.

1.Temporarily place the amplifier as close as possible to the selected mounting location.

2.If your auto sound system has four sep- arate line out jacks, connect the auto sound system to the amplifier.

CH 4

CH 3

CH 1 CH 2

Right Rear	Right Front
Auto Sound System
Left Rear	Left Front

8 Connecting Inputs