Rangemaster RDW6012FI manual Interrupting the programme, Delayed start programming, ½ Load Button

Interrupting the programme

A cycle that is underway can be modified if it has only been running for a short time. Otherwise, the detergent may have already been used, and the appliance may have already drained the wash water. If this is the case the detergent dispenser must be refilled; see ‘Loading the detergent’.

To cancel a programme that is underway, carefully open the door and press the programme button and hold it in for about 3 seconds.

Caution! There is a risk of water coming out from inside the appliance. DO NOT open the door fully until the spray arm has stopped rotating.

When you open the door, the dishwasher will beep ten times every thirty seconds.

If the appliance has already heated up or the hot water was switched ON and then the appliance door opened, leave the door ajar for several minutes and then close.

Delayed start programming

You can delay the start of a programme in increments of 2 hours up to 12 hours.

1.Switch dishwasher ON.

2.Immediately press the Delayed Start button (Fig.2-17), the delayed start indicator lights, the start time for the wash cycle can be delayed for 2, 4, 6, 8, 10 or 12 hours (Fig.2-18).

3.Press the Delayed Start button as many times as necessary until the numerical display shows the required delay.

4.To cancel the time delay setting, pressing the Delayed Start button until the delayed start indicator goes out.

5.Press programme button to choose the desired programme.

6.If the door is closed, the delay indicator will blink and the indicators will go out as the time counts down, the programme will start until the delayed start indicator goes out and the wash cycle begins.

½ Load Button

This function allows the dishwasher to wash dishes using only the upper rack if there are not enough dishes for a full load. This will allow you to save on water and energy consumption.

To select ½ load:

1.Select the programme and then press the ½ load button (Fig.2-19)– the ½ load indicator blinks.

2.Close the door. The programme starts automatically.

To cancel the ½ load

1.Open the door slightly.

2.Press the programme button and hold it in for about 3 seconds.

Please keep in mind that the amount of detergent should also be adapted to the ½ load.

Fig.2-17

6h 4h 2h

ArtNo.800-0213 - Operation 3

Fig.2-18

6h	4h	2h	6h	4h	2h
�������			�������
6h	4h	2h	6h	4h	2h
�������			��������
ArtNo.800-0214 - RDW6012 - Operation 4 timer settings					2h
6h	4h	2h	6h	4h
�������			��������
			1	Fig.2-19

2

ArtNo.800-0215 - Operation 5

9