Inspection
Remove Packaging
Your wine cooler has been packed for shipment with all
parts that could be damaged by movement securely fas-
tened. Before using, be sure all packing materials and
tape have been removed.
Important
Keep your carton packaging until your wine cooler has
been thoroughly inspected and found to be in good con-
dition. If there is damage, the packaging will be needed
as proof of damage in transit.
How to Install Your
Refrigerated Wine Cooler
Select Location: The proper location will ensure peak
performance of your appliance. Choose a location
where the unit will be out of direct sunlight and away
from heat sources. Best performance will be main-
tained when installed within the following parameters:
Cabinet Clearance: Ventilation is required from the
bottom front section of the unit. Keep this area open
and clear of any obstructions.
Electrical Connection
WARNING - THIS APPLIANCE MUST BE EARTH-
ED. All external wiring must comply with the IEE
Regulations for the Electrical Equipment of Buildings.
Connections to the electrical supply can be made
with either a plug and socket or be permanently
wired via a double-pole switch.
The appliance is supplied with a 250V PVC(85°C)
core cable (0.5mm²x2.5 metres long). Any replace-
ment cable fitted must follow this specification. The
unit may be supplied with either a moulded or
rewirable plug. Should the plug not fit the socket at
the installation site it should be removed and
replaced with the correct type of plug.
Moulded Plugs: If a moulded plug is fitted which is
not suitable, it must be removed and disposed of. To
avoid the risk of electrocution, a plug must not be left
where a child may plug it into a supply socket. It must
not be used for any other appliance. Athree pin plug
to BS 1363 with a capacity of not less than 13A must
be used and fitted with a 13Afuse ‘ASTA’ approved to
BS 1363.
If you replace the fuse, the cover must be refitted. If the
cover is lost, the plug must not be used until a replace-
ment has been obtained from your supplier. The colour
of the fuse cover is that of the insert in the base of the
fuse recess or elsewhere on the plug. Always state this
colour when ordering a replacement cover.
2