Installation
Introduction
Your Raymarine CAM 50 CCTV camera is a good quality color camera available in two models:
•E03016 - NTSC format.
•E03017 - PAL format. It is waterproof to IP63 standard and suitable for use in indoor locations such as the wheel house, salon or engine room.
Safety notices
CAUTION: Power supply
The CAM 50 CCTV camera is suit- able for use on a 12 V DC power supply only.
CAUTION: Power supply
A 0.5 A
CAUTION: Installation
This product IS NOT suitable for installation underwater.
This product contains no user serviceable parts.
What’s in the box?
12V DC ONLY
What tools are required?
Drill bit | Phillips |
Drill | screwdriver |
|
What accessories are available?
To enable you to complete the cabling to instal your camera the following are available:
•E06017 - 5 m extension cable.
•E06018 - 15 m extension cable
The cables can be joined in any combination to achieve the required cable length.
Cable runs
You need to consider the following points before installing your camera cables:
•You need to connect the camera to a display unit and power supply.
•All cables should be adequately clamped and protected from physical damage and exposure to heat - avoid running cables through bilges or doorways, or close to moving or hot objects.
•Acute bends must be avoided.
•Where a cable passes through an exposed bulkhead or deckhead, a watertight gland or swan neck tube should be used.
•CCTV camera cables cannot be cut and rejoined.
Installation
Having selected a suitable installation site:
1.Remove the camera dome by gently turning it counter- clockwise to release the bayonet fixing. 2.Remove the camera cover by gently pulling it
away from the
Camera dome baseplate.
| 3.Hold the base- | |
| plate in the | |
| required position | |
| and using a | |
| pencil mark the | |
| fixing holes. | |
Dome | 4. Using a suitable | |
drill bit make pilot | ||
| ||
| holes for the fixing | |
| screws. | |
| 5.Fix the camera | |
| and baseplate into | |
| position using the | |
| two screws | |
Cover | provided. | |
6.Make sure that | ||
| ||
| the cable is | |
| placed in the | |
cable slot of the camera baseplate to | ||
ensure that it is not pinched when the | ||
baseplate is secured in position. |
With the camera installed you can now adjust the field of vision .
A
B
You cabn adjust both the pan and the tilt of the camera.
To adjust the pan of the camera:
1.Loosen screw A.
2.Gently turn the camera assembly until the lens is pointing in the required direction.
3.Gently pinch screw A to secure the camera in position.
To adjust the tilt of the camera:
1.Loosen screw B.
2.Holding the edges of the camera plate gently tilt the camera up or down into the required position.
3.Gently pinch screw B to secure the camera in position.
You should now connect the camera to your display and check that the required image is being shown.
Either adjust the image by changing the pan and tilt as detailed above, or, replace the camera dome and cover to complete the installation.
Cable connections
The extension cables from the camera to the display unit are joined using the male/female twist connectors.
The adapter cable should be used to connect the display and the power supply to the camera. The adapter cable connections are shown below.