Raypak manual Dialing into the Y-200 Programming Keys and Operation, Y-308 Modem Module

Installation and Operating Manual Y-308 Modem Module

Dialing into the Y-200 Programming Keys and Operation

1.The “U” key takes you up through the screen displays and in the program mode changes the character above the cursor scrolling up.

2.The “D” key takes you down through the screen displays and in the program mode changes the character above the cursor scrolling down.

3.The “P” key puts you into the program mode.

4.The “M” key takes you out of the program mode.

5.The “<”key moves the cursor to the left.

6.The “>” key moves the cursor to the right.

7.Now you can program or set up the Y-200 re- motely.

8.To get into the password-protected windows above #19 you must go to window #19 then type “P” then “M” then use the “U” and “D” keys to scroll through screens #20 through #33.

Dialing out from the Y-200 Computer Preparation

1.Activate the HyperTerminal on your computer

2.Type “AT” then <Enter>.

3.You should see the “OK” on your computer screen.

4.Type “ATS0=1” <Enter>.

5.You should see another “OK” on your computer screen. (Computer answers on one ring).

6.The computer is now set up to receive calls from the Y-200 when there is an alarm condition.

7.The same thing can be accomplished by clicking on the “Call” and then on the “Wait for a call” button in the Hyper Terminal window.

Dialing out from the Y-200 (Alarm No- tification) Programming and Opera- tion

1.To program in the phone number the Y-200 should notify in case of an alarm condition:

a.Go to screen #30 (ON THE Y-200 CON- TROL ONLY).

b.Go into the program mode and enter the phone number by using the keypad up or down and left or right arrows.

c.If you program in too many numbers and you want to erase the extra numbers, insert a “#” sign after the last number you want to keep. To verify, exit the program mode and screen #30 and then go back to screen #30. The # sign indicates the end of phone num- ber.

d.Up to 16 numbers can be stored.

2.To program in the Alarm Call ID:

a.Go to screen #31.

b.Enter the ID code of the Y-200 location.

c.If you program in too many characters and you want to erase the extra characters, put the “#” sign after the last number you want to keep. To verify, exit the program mode and screen #31 and then go back to screen #31. The # sign indicates the end of the ID code.

d.Up to 16 numbers or letters can be stored.

3.To program the Alarm Call Retry:

a.Go to screen #32.

b.Program in the number of times you want the Y-200 to try and call out when there is a fault condition (00 to 20).

c.Modem activity is also displayed

4.To program the Alarm Call Event:

a.Go to screen #33.

b.Program in the alarm conditions you wish to be enabled. The cursor appears under the first “A” when in the program mode.

c.Screen will change to an alarm condition and at the end it will show weather it is in the Enable or Disable condition.

3