Razor E500S owner manual Assembly and SET-UP, Charging the Battery, Attaching the Handlebars

ASSEMBLY AND SET-UP

q Charging the Battery

Your electric scooter may not have a fully charged battery. Therefore it is a good idea to charge the battery

prior to use.
•	Initial charge time: 12 hours	•	Run time: up to 40 minutes
•	Recharge time: up to 8 hours,	•	Average battery life: 250 charge/discharge cycles
	depending on the level of depletion

Charger

Port

Charger
Plug	2 Plug the charger plug into a
1 Plug the charger port into
the port on the scooter. The	wall outlet.
charger works with the power
switch in either the on or off
position.

qAttaching the Handlebars

1 Insert handlebar assembly	2 Handlebar assembly should	3 Once stem is all the way
into fork.	be all the way in with the collar	down and no more threads
	covering the threaded portion	on fork are visible, tighten
	of the fork. Spin the handlebar	two collar bolts with 5 mm
	stem clockwise down onto the	hexagonal key wrench.
	fork to ease installation.

q Attaching the Seat

1 Remove the four bolts	2 Position seat onto frame and	3 Secure seat with the
from the frame with the 5 mm	align holes.	four bolts.
hexagonal key wrench.

q Riding Your Scooter

Testing the Brake – To use the brake, squeeze the brake lever to increase the pressure on the brake. The brake lever is fitted with a cable adjuster to compensate for cable stretch and/or to fine-tune the lever movement to brake engagement. If brake is not engaging properly, follow instructions for adjusting the brake on page 4.

3

WARNING: Always disconnect your E500S scooter from the charger before cleaning with liquid.

Note: If your charger does not look like the one illustrated, your unit has been supplied with an alternative charger. The specifications and charging procedure would not change.

The charger has a small window with one LED or two LEDs to indicate the charge status. Refer to the illustration on the charger unit for the actual “charging” and “charged” status indications for your model charger.

Chargers have built-in over- charge protection to prevent battery from being over- charged.

Be sure to properly align the groove on the charger input plug with the corresponding socket on the case; otherwise, no charging action will occur.

WARNING: Failure to properly tighten the collar bolts may allow the handlebars to dislodge while riding and may cause you to lose control and fall. When correctly tightened, the handlebars will not rotate out of alignment with the front wheel under normal circumstances.

Note: The cable and wire assembly from the handlebar must be routed as shown in step 1, not wrapped around the steering tube or handlebar. Sharp bends or twisting of the brake cable can cause the brake to malfunction.