Installation (continued)
NOTE: The binding posts will accept a maximum wire gauge of 14 AWG and a minimum wire gauge of 18 AWG. Please refer to the NEC (National Electrical Code) for further information regarding the permissible wire size.
2. Install speaker into the ceiling.
NOTE: Carefully tuck the speaker wires up into the ceiling so they
do not get pinched.
3. Set the three switches located on the face of the speaker to the proper setting
according to the installation, see the guidelines below:
A: The
standard 8 Ohm operation slide the switch to the proper position on the face of the speaker.
NOTE: In 70/100 volt operation, be sure to appropriately set the selector according to the power output of the amplifier being used and the number of speakers being installed. In 8 Ohm operation, be sure to set the selector to the 8 Ohm setting.
B:Slide the switch into the proper position in order to choose from 2, 4, 8 and 16 Watt taps in 70/100 volt operation.
C:To customize the sound of the tweeter slide the switch located on the front baffle of the speaker to either: +3dB, 0dB,
A: Switch for 70/100 Volt | B: Switch for Watt Taps in | C: Switch for Tweeter |
or 8 Ohms Operation. | 70/100 Volt Operation. | Adjustment. |
3