3.Connect the small end of the power supply into the POWER 9V AC jack on the back of the answerer. Plug the other end into an AC power outlet. The unit announces “please wait for the beep.” The unit pauses while the MESSAGE indicator flashes and then beeps again when it is ready for setup or to answer calls with the default greeting and settings.
CAUTION: Only use the ATLINKS USA, Inc.
IMPORTANT INSTRUCTIONS FOR MOVING THE ANSWERER:
To move the answerer to a different location in the house, follow these instructions:
1.Disconnect the phone line or any phones you may have connected to the unit.
2.Install a battery, if you have not already done so.This will ensure that your messages are not lost. See “Installing the Battery.”
3.Go to the electrical outlet and unplug the power supply.
4.Move the unit and phone line to the desired location.
5.Plug the power supply into an electrical outlet.
6.The MESSAGES indicator flashes slowly if there is a new message.
7.Connect all necessary phone lines.
7
