RCA 3-8120 Listening to a Compact Disc, Ac Outlet Power Supply, Batteries Power Supply, Adaptor

ELECTRONIC SHOCK

PROTECTION

:40SEC

TRACK MIN SEC

BASS BOOST

esp

DIGITAL SOUND PROCESSING

DBBS

3-8120 rev.1 EN 5/2/01 4:52 PM Page 6

THE CD PLAYER

THE CD PLAYER

EN	Model Number	Adaptor	Batteries
	3-8120	5-4079B	AAx2
		(120V 60 Hz)	(not included)
		(not included)

Listening to a Compact Disc

(This unit is compatible with CD-R and CD- RW discs for playback)

1. Slide the OPEN switch to the right to

open the door. Insert a disc and

press lightly on the centre to

tape deck and plug the cord into the	EN
CD player’s PHONES jack.
3 . Insert a compact disc and press PLAY/
PAUSE button. Adjust CD player’s volume
to a mid level (make sure the Bass Boost is
turned off).

AC OUTLET POWER SUPPLY

(NOT INCLUDED)

BATTERIES POWER SUPPLY

Refer to the table for details of the bat-

secure disc loading. Close the door. Press

PLAY/PAUSE button. RD DISC

will show on the display

4.Use the car stereo to adjust volume, tone. Adjust the volume of your

CD

Refer to the above chart for adapter (transformer) information that can be used with your unit.

AC/DC adaptor is purposed for dry indoor use only. Remove the jack from the device to use it with the batteries.

Note : Power is fed to the unit even when it is not functioning. To cut the power sup- ply off, the AC/DC adaptor must be unplugged.

CAR (DC) POWER SUPPLY

teries required to operate your unit. Recharge function (Thomson Models) — To charge Ni-Cd batteries (not included): Insert 2 rechargeable batteries in the com- partment. Turn the switch to the ON posi- tion at the back of the unit. Connect the main adaptor. The batteries take about eight hours to become fully charged if the player is not operating.

Important : If you use your CD player with non rechargeable batteries, turn

and then the total num-

ber of tracks and

time of the CD. If the	1
disc compartment is	PROG.
empty or the disc	MODE
	:40sec
cannot be played,	SHUFFLE
	esp
NODISC will show on
the display.
2. Slide CONTROL
switch to HOLD
position to lock the
button to avoid acci-

P

REV

FWD

PLAY

STOP

PAUSE

player for better volume control.

5.Before ejecting the cassette after you have finished lis-

tening, make sure the car stereo’s vol- ume is turned down.

The ELECTRONIC SHOCK PROTECTION*

ADAPTOR (NOT INCLUDED)

Plug the car (DC) power supply adaptor into the DC in 4.5V jack at the rear/side of the CD player & then into the cigarette lighter receptacle in your car.

OFF the switch at the back of the unit in order to prevent any damage to the unit or batteries.

	DI
	GI
dental activation of	TA
	P	L A		NTI-
		ER	SONA

unwanted functions.

You can also change tracks or quickly listen to part of a track by pressing or holding FWD or REV.

Listening to a CD in your car

(NOT INCLUDED)

1.Select a power source (either battery power or the car DC adaptor)

2.Insert the cassette adaptor into the

			EM		system prevents sound
		ST
	SY
SHOCK YER
L CD PLA					interruptions when impacts
				or vibrations occur. Electronic
anti-shock consumes less power and
					increases the battery life.
					Therefore, the ESPX
					function is always ON.
		:	40	SEC
					After many successive
					impacts, the buffer might
					be emptied causing a
brief sound interruption for the memory
to reload. The buffer is 40 seconds long.

3

4