RCA ANT2020X manual Assembling The Mounting Bracket, Non - Vertical Mounting

Assembling The Mounting Bracket

The ANT2020 consists of an off-air bracket and hardware, an offset mast, and eleven inch extension, and a swaged tube for non-vertical mounting. The bracket may be used with a satellite dish or alone to mount this off-air antenna.

For vertical mounting, place the off-air bracket behind the Satellite Mounting Bracket and follow the mounting instructions that came with the satellite system. Insert eleven inch extension into offset mast. Drill a hole through both and secure the two together with #10 self tapping screw. With the bracket secured to the wall or other vertical surface, mount the offset mast assembly to off-air bracket using U-bolts, mast clamps, lockwashers, and nuts as shown. Adjust the offset mast assembly so the off-air antenna is horizontal and does not interfere with the DBS antenna.

The off-air bracket may be used alone to mount an off-air anten- na. Mount the off-air bracket to the wall with the four lag bolts supplied and mount the offset mast to off-air bracket as shown.

For non-vertical mounting, place the off-air bracket behind the Satellite Mounting Bracket and follow the instructions that came with the satellite system. With the off-air bracket secured to the non-vertical surface, mount the swaged tube to the off-air brack- et using U-bolts, mast clamps, lockwashers, and nuts shown. Mount offset mast to swaged tube. NOTE: If additional off-air antenna height is needed or desired, insert eleven inch extension into offset mast. Drill a hole through both and secure the two together with #10 self tapping screw. Adjust the swaged tube and offset mast/offset mast assembly so the off-air antenna antenna is horizontal and the mast does not interfere with the DBS antenna. Drill a hole through offset mast/offset mast assembly and swaged tube. Secure the two together with #10 self tapping screw. NOTE: Be sure to route coaxial cable through the slot provided at top of offset mast when making coaxial connections.

Offset Mast

Dish

#10 Self

Tapping Screw

11" Extension

Offair Bracket

Lag Bolts

Nuts

U-Bolts

Lockwashers Mast Clamps

Dish Mouting Bracket

Vertical Mounting

Dish

Offset Mast

#10 Self

Tapping Screw

Lag Bolts

U-Bolts

Swaged Tube

Mast Clamps

Dish Mouting Bracket

Nuts

Off-air Bracket

Lockwashers

Non - Vertical Mounting

One Year Limited Warranty

Thomson Consumer Electronics will replace this antenna if found to be defective in materials or workmanship. Return it postage prepaid to the address below for prompt, no charge replacement with a current equivalent antenna.

This replacement is TCE’s sole obligation under this warranty. TCE will not be responsible for any incidental or consequential damages, or for any loss arising in connection with the use or inability to use this product.

This warranty gives you specific legal rights, and you may also have other rights which vary from State to State.

© 1998 Thomson Consumer Electronics, Inc. Product Exchange Center, 32B Spur Drive El Paso, Texas 79906