INSTALLATION CONTINUED
the straight pipe with 5 holes (as shown in diagram B). Now place assembled pipes into small end of double mounting clamp and loosely secure clamp with wrench (as shown in diagram C).
5. Mount pipe and mounting clamp assembly on “Support Column” |
INSTALLATION CONTINUED
Output to the TV’s
of DBS system antenna (as shown in diagram D). |
6. Mount dish, antenna, and spreader bracket assembly on pipe |
and mounting clamp assembly (as shown in diagram E). Note |
that antenna assembly can be rotated to clear any obstruction |
or for fine tuning. The ANT2050X overall height can be adjusted |
by resetting the 5 hole pipe using its other |
(as showin in diagram F). |
I.
75 Ohm "F"
Jack Input
From Roof
or OutsideSatellite
Cable
Separating
Diplexer
DBS Receiver
DBS Video/Audio
In Out
Television | Back |
|
Video/Audio |
| |
75 | Ohm "F | |
In |
| |
Jack | ||
|
| Input |
E. | F. | Keep |
|
| Horizontal |
7.IMPORTANT: Make sure that dish assembly is fully horizontal and that no part of the dish itself covers the front surface of the DBS antenna (as shown in diagram G).
8.Connect
G. H.
X
House
LNB
(as shown in diagram H).
9.An external “separating” diplexer is used to separate the antenna’s VHF/UHF signal from the satellite signal before the coaxial cable is connected to the DBS receiver (as shown in diagram I). Connect the VHF/UHF cable from the external “separating” diplexer DIRECTLY to the TV’s 75 ohm “F” jack for best results! (It is NOT recommended to connect the VHF/UHF cable DIRECTLY to the DBS receiver since it will likely degrade VHF/UHF picture quality.) The satellite signal cable from the external “separating” diplexer should be connected DIRECTLY to the DBS receiver 75 ohm “F” jack. The DBS connection to the TV can be done with RCA type patch cords, which connect the DBS receiver’s Video/Audio Output to the TV’s Video/Audio Input. The best connection, however, is made using the DBS receiver’s
UHF/VHF Cable
FOR OPTIMAL PERFORMANCE
• Mount the antenna a minimum of 8 feet | In the attic |
high (the higher, the better). |
|
• The ANT2050X is an omnidirectional antenna; however as with any antenna, it performs best in locations where there is a clear path, or a “line of sight”, to the approximate location of the TV transmitters in your area.
Note: Even with the advanced design of this antenna, large obstructions such as canyon walls, mountain sides, and other
objects can impair performance. Therefore, it is best to minimize any obstructions that block the “line of sight” by mounting the DBS antenna on the roof or on the highest possible point.
• When the DBS antenna is | J. |
mounted less than 8 feet high, | |
the antenna can be mounted | "L" Pipe |
on the side of the house, chim- | |
ney, or in the attic to achieve |
|
the required height. Wood |
|
screws or the included mortar |
|
“anchors” can be used with the |
|
antenna dish mounting clamp |
|
(as shown in diagram J) to |
|
mount the antenna on the side |
|
of the house, the chimney, or |
|
in the attic. |
|