Powering the Camcorder

Using the Rechargeable Battery

The battery must be charged as described on the next page before it can be used the first time. Initial charging takes approximately 90 minutes. When fully charged, the battery supplies approximately 75-95 minutes of operating time– depending on how much the monitor, zoom, and pause are used. Conserve battery power by turning the camcorder off during recording breaks.

Battery Release Button

Safety Precautions

•Do not short the battery’s terminals.

•Do not attempt to disassemble or modify the battery. No user- serviceable parts are inside.

•Use the battery only with specified adapter/ chargers and camcorders.

•Throwing the battery into a fire or exposing it to excessive heat – over 149 degrees F (65 degrees C) could be hazardous.

Attaching a Charged Battery

If the DC cable is attached to the camcorder, remove it before attaching the battery.

1.Lift the viewfinder.

2.Slide the battery into the back of the camcorder. Make sure the arrow diagram on the battery points down so the contacts on the battery and camcorder match.

3.Turn the Power Switch to record ( M or A ). The power indicator lights.

Removing a Battery

Press and hold the BATTERY RELEASE button. Slide the battery up and out to remove.

12