Powering the Camcorder
Charging the Battery
If the DC cable is attached to the
DC OUT jack on the Adapter/Charger, remove it.
1.Make sure the arrow on the battery faces up and points to the Adapter/Charger’s POWER light.
2.Hold the battery flush against the Adapter/Charger and slide it in the direction of the arrow.
3.Plug the Adapter/Charger into the nearest AC power outlet (100- 240V, 50/60Hz).
4.If the battery is properly connected, the CHARGE indicator blinks.
Arrow Marker
POWER Indicator
CHARGE Indicator
Note: If you try to charge a battery that has not been charged for a long period of time, it may take a few minutes for the CHARGE indicator to flash.
5.After the battery is charged, the CHARGE indicator stops blinking and remains lit.
6.Remove the charged battery by sliding it off the Adapter/Charger.
7.Attach the charged battery to the camcorder as described on the previous page.
To AC Wall Outlet
Adapter/Charger model 247801
DC OUT Jack
CAUTION
When a battery is attached to the Adapter/Charger, do not turn them upside down. The battery may fall off and be damaged or cause injury.
13