USING VEHICLE BATTERY POWER

You can power the TV from a vehicle’s 12V power source (such as a cigarette-lighter socket) using a 6V, 550-mA DC adapter and a size B Adaptaplug adapter (neither supplied). Both are available at your local RadioShack store.

Cautions:

You must use a power

!source that supplies 6V DC and delivers at least 550

mA. Its center tip must be set to positive and its plug must fit the TV's DC IN 6V jack. Using an adapter that does not meet these specifications could damage the TV or the adapter.

•Always connect the DC adapter to the TV before you connect it to the power source. When you finish, disconnect the adapter from the power source before you disconnect it from the TV.

You can use an optional DC adapter to power the TV from a vehicle’s cigarette-lighter socket if the vehicle has a 12-volt DC, negative ground electrical system. Your local RadioShack store sells a variety of adapters.

Set the adapter’s voltage switch to 6V. Insert the Adaptaplug into the adapter’s cord, aligning + with TIP. Plug the Adaptaplug’s barrel plug into the TV’s DC IN 6V jack. Unplug the vehicle’s cigarette lighter and plug the large end of the DC adapter cord into the cigarette-lighter socket.

Caution: Do not leave the adapter plugged into the cigarette-lighter socket or connected to the TV when you are not using the TV.

Note: If the TV does not operate properly when you use DC power, be sure the cigarette-lighter socket is clean and that the adapter’s plug is properly connected to the socket.

Connections

USING THE TV AS A MONITOR

You can play back the signal from an audio/ video component connected to your TV using

a special cable (not supplied), available through your local RadioShack store (RSU 10005890).

Connect the cable’s yellow plug to the component’s video output jack and its white plug to the component’s audio output jack. Then, plug the cable’s sub-mini plug into the TV’s AUDIO/VIDEO jack.

Using Your TV

1.Extend the rod antenna and slide UHF/ VHF/OFF to VHF or UHF. The TV starts scanning and stops at the next active channel in the selected band.

2.Press TUNING to tune to a different channel. The tuning line on the screen aligns with the selected channel number below the screen.

3.To adjust the volume, rotate VOLUME located on the right side of the TV.

4.To adjust the picture to the desired brightness, rotate BRIGHT located on the right side of the TV. The brightness also changes with the screen’s angle.

Notes:

•If desired, fold out the stand on the back of the TV and lean the TV on a flat surface at a convenient angle.

•If reception is poor, adjust the length or angle of the rod antenna. If the TV is inside a metal or concrete building, moving closer to a window might improve reception.

BACKLIGHT

In low temperatures, the TV screen takes a few seconds to light, or it might be slightly red in color. This is not a malfunction. Normal operation resumes after a few seconds.

USING AN EARPHONE

For private listening, you can connect an optional earphone with a 1/8-inch plug to the EAR jack. This automatically mutes the built-in speaker.

3