Using Advanced Features
Placing Channels in Memory (Autoprogramming)
Only channels
You may want to add or delete a few channels if some stations have weak signals or were off the air when the TV was programmed. Refer to the Add or Delete Channels section below.
1.Place channels in memory (Autoprogram)
13
Controls Alarm Adjust Setup
English Français Español
Autoprogram
Label: 00Clear
Channel Memory: 13 Stored
Cable/Air: Cable
A. Hook up an antenna, cable or |
components before you begin |
these steps or you will not be |
able to add channels into |
memory. |
B. Press MENU repeatedly to |
select the Setup Menu. This |
menu is white. |
C. Press CHANNEL down to |
highlight Autoprogram. |
15
Controls Alarm Adjust Setup
English Français Español
Autoprogramming
Label: 00Clear
Channel Memory: 15 Stored
Cable/Air: Cable
D. Press + to start the TV adding |
all active channels into |
memory. |
E. Wait until the TV has cycled |
through all the channels and |
returns to the original channel. |
F. Press CLEAR to remove the |
menu from the screen when |
you are finished. |
2.Add or delete channels
13
Controls Alarm Adjust Setup
English Français Español
Autoprogram
Label: 00Clear
Channel Memory: 13 Stored
Cable/Air: Cable
13
Controls Alarm Adjust Setup
English Français Español
Autoprogram
Label:l 00Clear
Channel Memory: 13 Erased
Cable/Air: Cable
A.Press MENU repeatedly to select the Setup menu.
B.Press CHANNEL down to highlight Channel Memory.
C.Press + to underline the channel number.
D.Select the channel number you want to add or delete with the number buttons.
E.Press + to add or delete a channel (you will see Stored on the screen when added and Erased when deleted).
F.Repeat D and E for more channels.
G.Press CLEAR to remove the menu from the screen when you are finished.
9
