Attaching wall mount plate
Drywall Installation
1.Use a stud finder to locate a wood stud where you want to install the mount. NOTE : It is required that the wall mount plate be attached to wall studs.
2.
3.Place the wall mount plate against the wall, with the cord management channel towards the bottom. Level it using the bubble guide. Mark the locations on the wall where the mount is to be installed.
4.Drill holes at each marked location using the enclosed wood drill bit.
5.Secure the wall mount plate to the wall, using one dr y wall screw, but do not completely tighten it yet.
6. Using the integrated bubble level, carefully adjust the wall mount plate until it is level.
7.Inser t the remaining screws and tighten all three screws completely.
Concrete/Brick Installation
1.Place the wall mount plate against the wall with the cord management channel towards the bottom.
2.
3.Place the wall mount plate aside.
4.Using an electric drill and a 5/16" ( 8mm) masonr y bit, drill holes in the marked locations.
5.Remove any excess dust from the holes.
6.Inser t a concrete anchor into each hole. If necessar y, use a hammer to lightly tap each anchor into place so they are flush with the wall.
7.Once all anchors are in place, place the wall mount plate back into position. Using the integrated bubble level, carefully adjust the wall mount plate until it is level.
8.Attach the wall mount plate, using the dr y wall screws provided.
9.Make sure all screws are tightened and secure.
Attaching the TV mount plate
1.Unplug your flat panel T V before star ting this step of the installation.
IMPORTANT: NEVER lay the T V face down as this may cause damage to the viewing sur face.
2. Before attaching the T V mount plate to the T V, determine which hardware to use. Examine the back of your T V. If the back is flat, use the M4x12mm bolts. If your T V has a recessed back, use the longer M4x30mm bolts and 1/2" spacers.
3.Af ter you have determined which bolts to use, attach the T V mount plate to the back of your T V.
NOTE : Be careful not to
Attaching the TV mount plate to the wall mount plate
1.To complete the installation, slide the T V mount plate with your T V attached into the wall mount plate.
2.
3.To remove the T V, push in on the clip and slide the T V mount plate up.
4.For additional security and stability, inser t the security bolt into the hole located at the base of the unit.
5.Tighten, using the Allen Wrench provided.
