RCA PRO-SW220P manual Connecting To Power, Adjusting The Volume, Rotate VOLUME CONTROL to MIN

You need two pairs of speaker pins (available at your local RadioShack store) to make the connection.

Follow these steps to connect the wires to each terminal using speaker pins.

1.Separate the conductors for a length of about 2 inches on the end of each wire. Then strip 1/2 inch of insulation from the ends of each conductor and twist the wire ends.

2.Position each wire end between the open barrel ends of the speaker pin.

To PRO-SW220P

From Left or Right Speaker

3.Using a pair of pliers, crimp the open barrel ends of the speaker pin to hold the wire ends in place.

4.Plug the speaker pin into the proper terminal on the PRO-SW220P.

CONNECTING TO POWER

Plug the PRO-SW220P’s AC power cord into an AC outlet.The STANDBY indicator lights green. If the subwoofer does not

receive a signal for about 11 minutes the STANDBY indicator lights red.

ADJUSTING THE VOLUME

Once you have made all connections, follow these steps to adjust the PRO- SW220P’s volume.

1.Rotate VOLUME CONTROL to MIN.

2.Turn on your amplifier/receiver and another component (such as a radio, cassette player, CD player, or turntable).

3.Begin playing an audio source (such as a radio) and adjust the amplifier/ speaker’s overall volume to a comfortable level. Rotate VOLUME CONTROL on the PRO-SW220P clockwise a little at a time, until you achieve a pleasing balance of bass between the PRO-SW220P and the main speakers (and satellite speakers, if used). Bass output should not overpower the main speakers, but should blend across the entire musical range.

5