RCA PRO-X55AV manual Attaching the Rubber Feet, Connections

40-5003.fm Page 2 Friday, August 6, 1999 8:44 AM

Note: When you use the 1/4-inch wall- mount bracket, remove the screw on the back panel of the speaker so you can thread the ball shaft. For any other type of mounting bracket, use the mounting holes (indicated by the arrows) and leave the screw in place.

ATTACHING THE RUBBER FEET

Rubber feet are supplied with your speaker so it will not scratch your furniture. With the thicker feet (marked A) positioned toward the front corners of the speaker and the thinner feet (marked B) positioned toward the back corners, remove the feet from the paper backing and press each onto the bottom of the speaker.

speaker wire for a distance of 50 feet or less. For a distance greater than 50 feet, use a heavier 16-gauge wire.

For the maximum bass response and overall best performance, connect the speaker in phase (– to – and + to +).

Speaker wire is either color-coded, with a different color on each side, or coded with a ridge or stripe on one side to identify the wire’s different sides, making the connection process easier. RadioShack stores sell speaker wire to meet most needs.

Follow these steps to prepare the wire and connect the speaker.

1.Separate the wire conductors for a length of about 2 inches, then remove about 1/2 inch of insulation from the wire’s ends using a wire stripper.

2.Push down the speaker’s black tab to open the negative (–) terminal and insert one of the wire’s conductors. Release the tab.

CONNECTIONS

With the speaker placed at the desired location, measure the distance from the speaker to the amplifier. Use 18-gauge

2

Black Tab