RP3536 EN_F 16/7/07 9:43 AM Page 1
User manual
Guide de l’utilisateur
RP3536
IT IS IMPORTANT TO READ THIS INSTRUCTION BOOK PRIOR TO USING YOUR NEW PRODUCT FOR THE FIRST TIME.
NOUS VOUS RECOMMANDONS DE LIRE CE MANUEL D’INSTRUCTIONS AVANT D’UTILISER VOTRE NOUVEAU PRODUIT POUR LA PREMIÈRE FOIS.
Powering the Recorder
POWER
There are two ways to supply power to your recorder:
BATTERY INSTALLATION
1.Press down on the battery door and slide in the direction of the arrow.
2.Insert two "AA" batteries (not included) as shown in the diagram on the back of the unit.
3.Replace the battery door.
IMPORTANT BATTERY INFORMATION
•Alkaline batteries are recommended for best results. Using
•If you do not intend to use the unit for a month or more, remove the batteries to avoid leakage or subsequent damage.
•Dispose of batteries in the proper manner, according to federal, state and local regulations.
•Any battery may leak electrolyte if mixed with a different battery type; if inserted incorrectly; if all batteries are not replaced at the same time; if disposed of in fire; or if an attempt is made to charge a battery not intended to be recharged.
•Discard leaky batteries immediately to avoid possible skin burns or other personal injury.
AC/DC POWER CONVERTER (NOT INCLUDED)
You can use an AC/DC power converter to operate your recorder. Plug the barrel end of the converter into the recorder's 3V DC jack - automatically disconnecting the batteries - and then plug into an AC household outlet.
Using the Recorder
TO INSERT OR REMOVE A CASSETTE
Make sure all buttons are in their "off" (up) position before attempting to open the cassette compartment door.
1.Grasp both sides of the cassette compartment door and lift up.
2.Gently slide in a cassette with the exposed tape facing out and the side you want to hear/record showing through the cassette door window.
3.Close cassette compartment door.
CUE/REVIEW
This feature is helpful in finding the beginning or the end of the recorded segment on the tape. When in the Play mode, press and hold the F.FWD or REW button and listen for a change from noise to silence (signaling the end of the recording) or from silence to noise (beginning of recording).
When you reach the segment of tape you want to listen to, release the F.FWD or REW button. Use the same procedure if you want to skip a prerecorded portion or if you want to listen to the same segment again.
AUTOMATIC STOP
When the unit is operating in the Play or Record mode and the tape reaches its end, the unit will automatically turn off and return all buttons to their off position.
ERASING CASSETTES
To erase a tape or a segment of the tape, simply rewind and record over the unwanted material.
Care & Maintenance
PREVENTING ACCIDENTAL ERASURE
Whenever you make a recording, all material on the tape will be automatically erased.
When you have a recording you want to keep permanently, break out the rear left tab of the side you want to save.
When a cassette with the tab broken is inserted in the cassette compartment, accidental erasure is prevented by a lever in the mechanism that keeps the RECORD button from pressing down. Cellophane tape can be placed over the broken tab if you decide later that you want to record over the material on that side.
NOTE: This unit is equipped with a cassette sensing mechanism. This mechanism prevents the RECORD button from being pressed down when a cassette is not present.
CAUTION/CARE
Do not expose the unit to extreme temperatures, such as near a hot stove or inside a car parked under the sun. Such conditions can damage the unit. Always clean the unit with a soft cloth, dampened with water only.
Cleaning the Heads: Iron oxide particles will gradually build up on parts that touch the tape. This can cause a muffled sound. Use liquid head cleaner or a head cleaning tape to clean the heads.
QUIT SLACKING
A little bit of slack in your tapes can cause scratches on the tape, or in the worse case, the tape could break. If you notice some slack in the tape, use a pencil to tighten it up before you insert it.
Warranty
Limitation of Warranty:
•THE WARRANTY STATED ABOVE IS THE ONLY WARRANTY APPLICABLE TO THIS PRODUCT. ALL OTHER WARRANTIES, EXPRESS OR IMPLIED (INCLUDING ALL IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE) ARE HEREBY DISCLAIMED. NO VERBAL OR WRITTEN INFORMATION GIVEN BY THOMSON INC., ITS AGENTS OR EMPLOYEES SHALL CREATE A GUARANTY OR IN ANY WAY INCREASE THE SCOPE OF THIS WARRANTY.
•REPAIR OR REPLACEMENT AS PROVIDED UNDER THIS WARRANTY IS THE EXCLUSIVE REMEDY OF THE CONSUMER. THOMSON INC. SHALL NOT BE LIABLE FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES RESULTING FROM THE USE OF THIS PRODUCT OR ARISING OUT OF ANY BREACH OF ANY EXPRESS OR IMPLIED WARRANTY ON THIS PRODUCT. THIS DISCLAIMER OF WARRANTIES AND LIMITED WARRANTY ARE GOVERNED BY THE LAWS OF THE STATE OF INDIANA. EXCEPT TO THE EXTENT PROHIBITED BY APPLICABLE LAW, ANY IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE ON THIS PRODUCT IS LIMITED TO THE APPLICABLE WARRANTY PERIOD SET FORTH ABOVE.
How state law relates to this warranty:
•Some states do not allow the exclusion nor limitation of incidental or consequential damages, or limitations on how long an implied warranty lasts, so the above limitations or exclusions may not apply to you.
•This warranty gives you specific legal rights, and you also may have other rights that vary from state to state.
If you purchased your product outside the USA:
• This warranty does not apply. Contact your dealer for warranty information.
LIMITED WARRANY (CANADA)
Thomson multimedia Ltd. warrants to the purchaser or gift recipient that if any manufacturing defect becomes apparent in this product within 1 year from the original date of purchase, it will be replaced free of charge, including return transportation.
This warranty does not include damage to the product resulting from accidents, misuse or leaking batteries.
Should your product not perform properly during the warranty period, either:
1.Return it to the selling dealer with proof of purchase for replacement,
OR
2.Remove the batteries (where applicable), and pack product complete with accessories in the original carton (or equivalent).
— Mail prepaid (with proof of purchase) and insured to:
Thomson Ltd.
Product Distribution Center
6200 Edwards Blvd.,
Mississauga, Ontario, L5T 2V7
Canada
The provisions of this written warranty are in addition to and not a modification of or subtraction from the statutory warranties and other rights and remedies contained in any applicable legislation, and to the extent that any such provisions purport to disclaim, exclude or limit any such statutory warranties and other rights and remedies, such provisions shall be deemed to be amended to the extent necessary to comply therewith.
If you are unable to find a qualified servicer for out of warranty service, you may write to:
Safety Information
FOR YOUR RECORDS
In the event that service should be required, you may need both the model number and the serial number. In the space below, record the date and place of purchase.
Date of Purchase:
Place of Purchase:
SERVICE INFORMATION
This product should be serviced only by those specially trained in appropriate servicing techniques. For instructions on how to obtain service, refer to the warranty included in this Guide.
Main plug is used as the disconnect device, it shall remain operable and should not be obstructed during intended used. To be completely disconnected the apparatus from supply mains, the main plug of the apparatus shall be disconnected from the mains socket outlet completely.
The descriptions and characteristics given in this document are given as a general indication and not as a guarantee. In order to provide the highest quality product possible, we reserve the right to make any improvement or modification without prior notice. The English version serves as the final reference on all products and operational details should any discrepancies arise in other languages.
HEADPHONES USE
When you attach headphones (not included), the speaker is automatically silenced for private listening. Make sure you turn down the volume on the unit before you put on headphones. Increase the volume to the desired level only after headphones are in place.
This Class B digital apparatus complies with Canadian
Cet appareil numérique de la class B est conforme à la norme du
Thomson Inc.
P.O. Box 1976
Indianapolis, IN
5633753B (EN/F)
MIC SENSITIVITY SWITCH
Select HI sensitivity for recording at conferences or for general use.
Select LO sensitivity for close dictation.
RECORDING
1.Insert a blank cassette.
2.Select MIC sensitivity (HIGH or LOW).
3.Press the RECORD button. (The PLAY button will automatically be pressed at the same time).
NOTE: If the RECORD button does not depress, see "Preventing Accidental Erasure."
4.Speak normally into the microphone. To obtain the best recording quality, place the recorder with the microphone freely exposed to sound source and as close as possible.
5.When you finish recording, press the STOP button. NOTE: The ALC (Automatic Level Control) will set
the record level for optimum recordings, regardless
A
of the volume setting. Avoid recording near unwanted noise sources, such as air conditioners, fans, etc.
PAUSE
The PAUSE feature allows you to momentarily stop tape activity in any mode without resetting the control buttons.
To use, simply slide the PAUSE switch to the ON position. Slide the switch back to the OFF position to resume activity.
PLAYBACK
To listen to a prerecorded cassette:
1.Insert a cassette as explained above.
2.Press the REW button to rewind the tape to its starting point if necessary.
3.Press the PLAY button.
4.Adjust VOLUME to your desired level.
VARIABLE SPEED PLAYBACK
During the playback, you can adjust the speed of the prerecorded tapes by rotating the Variable Speed Playback knob towards the MAX (maximum) position. Tape playback will be approximately
F.FWD AND REW
When in the Stop mode, you can use these buttons to adjust the tape position. Press F.FWD to move th tape quickly forward. Press REW to move the tape quickly backward.
LIMITED WARRANY (US)
What your warranty covers:
• Defects in materials or workmanship.
For how long after your purchase:
• One year from date of purchase.
The warranty period for rental units begins with the first rental or 45 days from date of shipment to the rental firm, whichever comes first.
What we will do:
•Provide you with a new, or at our option, a refurbished unit. The exchange unit is under warranty for the remainder of the original product’s warranty period.
•Proof of purchase in the form of a bill of sale or receipted invoice which is evidence that the product is within the warranty period must be presented to obtain warranty service. For rental firms, proof of first rental is also required.
How to make a warranty claim:
•Properly pack your unit. Include any cables, etc., which were originally provided with the product. We recommend using the original carton and packing materials.
•Include evidence of purchase date such as the bill of sale. Also print your name and address and a description of the defect. Send via standard UPS or its equivalent to:
Thomson Inc.
Product Exchange Center
11721 B Alameda Avenue Socorro, Texas 79927
•Insure your shipment for of loss or damage. Thomson accepts no liability in case of damage or loss en route to Thomson.
•Pay any charges billed to you by the Exchange Center for service not covered by the warranty.
•A new or refurbished unit will be shipped to you freight prepaid.
What your warranty does not cover:
•Customer instruction. (Your Owner’s Manual provides information regarding operating Instructions and user controls. For additional information, ask your dealer.)
•Installation and setup service adjustments.
•Batteries.
•Damage from misuse or neglect.
•Products which have been modified or incorporated into other products.
•Products purchased or serviced outside the USA.
•Acts of nature, such as but not limited to lightning damage.
Product Registration:
•Please complete and mail the Product registration Card packed with your unit. It will make it easier to contact you should it ever be necessary. The return of the card is not required for warranty coverage.
Thomson Inc.
P.O. Box 0944
Indianapolis, Indiana, U.S.A.,
