Setting Up the VCR
Startup
5. Place channels in the VCR’s memory.
The first time you turn on the VCR or after a power interruption, the VCR displays a message on the TV screen prompting you to
Wait until the channel numbers stop changing. This takes about one to two minutes. The TV tunes to the lowest channel found. Then, pressing CHAN up or down selects only the active channels.
If you ever need to manually set up channels (Channel Setup) on the VCR because you change cable or antenna signals:
A. Press MENU to display the VCR MAIN MENU on the TV screen. If this menu does not appear:
•Make sure the TV is tuned to same channel as the 3CH.4 switch on the VCR or the TV’s video input (refer to TV’s manual).
•If you use a basic hookup, check the VCR indicator in display panel — it should be on. Press TV•VCR to turn it on.
•Check the connections.
B. Press 3 to display the CHANNEL SETUP menu.
C. Press 1 to begin
The VCR automatically selects CABLE (cable TV) or ANTENNA. If you need to change the setting manually, press 3.
CONNECT ANTENNA CABLE...
THEN PRESS CH UP
VCR MAIN MENU
1 TIMER PROGRAMMING
2 REVIEW PROGRAMS
3 CHANNEL SETUP
CHANNEL SETUP
1
2 ADD/REMOVE CHANNELS
3 TUNING MODE: CABLE
4 CABLE BOX SETUP
0 EXIT TO MAIN MENU
6. Add or remove channels from the VCR’s memory.
You may want to add or remove channels if some of the channels are not active, have weak signals, or you do not want to watch them.
It is best to place channels in memory using the AUTO- SEARCH CHANNELS feature described above before you add or remove channels since channels
A. Press MENU on the remote to see the VCR MAIN MENU
on the TV screen.
B. Press 3 to display the CHANNEL SETUP menu.
C. Press 2 to display the ADD/REMOVE CHANNEL menu.
D. Follow the directions on the screen.
E.Add or remove more channels by using the CHAN up and down buttons.
VCR MAIN MENU
1 TIMER PROGRAMMING
2 REVIEW PROGRAMS
3 CHANNEL SETUP
CHANNEL SETUP
1
2 ADD/REMOVE CHANNELS
ADD/REMOVE CHANNEL
CH 03
IS PRESENTLY ADDED
PRESS CLEAR TO REMOVE PRESS MENU TO EXIT
9
