WHP141 US IB REVC_K.qxd 5/25/05 12:17 PM Page 6
\HEADPHONE SET DESCRIPTION
For
1Rechargeable battery compartment
2 | ON/OFF switch | 3 |
| ||
3 | Recharging input |
|
4 | Power LED |
|
| indicator light | 4 |
1 2
5 Stereo LED indicator light
6 VOLUME control
7 CHANNEL switch
6
7
5
8Charging LED indicator light
9Audio Signal LED indicator light
10 Charging cable
11 DC IN power supply socket | 8 9 |
12CHANNEL switch
13Audio input cable
10
11 | 12 | 13 |
SUPPLIED ACCESSORIES
This headphone system includes accessories that enable you to use your wireless headphone set in a number of ways. (See section on Operation and Standard Usage, page 9)
3.5mm/.25 inch jack adaptor
Main power adapter
(AC/DC: 120 V ~ 60 Hz, 12 V = 150 mA)
BATTERY INSTALLATION AND INFORMATION
Your wireless headphone unit requires two rechargeable AAA batteries. Rechargeable batteries are uncharged when you purchase them. Before you can use the wireless headphones, the batteries must be charged for 16 hours. Follow these steps to install and charge the batteries.
Installing the Rechargeable Batteries
Take care to follow these steps to correctly install the batteries.
1.On the right headphone, locate the battery compartment (1).
Use the finger depression on the compartment to turn the battery compartment cover counterclockwise to remove the cover.
2.Insert two AAA rechargeable batteries, carefully following the markings inside to ensure the batteries are inserted properly, with the + and - ends in the correct positions.
3.Replace the battery compartment cover.
Charging the Rechargeable Batteries
To recharge the headset unit, follow the directions below. Note: The cradle/transmitter on the WHP141 is not a recharging cradle, although you may place the headset in the cradle during recharging.
Follow these steps to recharge the NiMH rechargeable batteries.
1.Make sure the ON/OFF switch (2), located on the right headphone, is in the OFF position.
2.Connect the AC/DC main power adapter to the DC IN power supply socket (11), located on the back of the cradle/transmitter.
3.Plug the adapter into an electrical outlet.
4.Connect the charging cable (10), located on the back of the cradle/transmitter to the recharging input (3), located on the right headphone. The headphones can either be placed in the cradle/transmitter or placed next to the unit. If the headphones are connected correctly, the charging LED indicator light on the cradle/transmitter (8) illuminate.
6 | 7 |