Note: You must reset the clock, digital tuner memories for the radio, and any other timer/memory devices when you reconnect the battery wire after wiring is complete.
2.Connect the equalizer/booster's black (ground) wire to a nearby part of the vehicle's metal frame.
Note: Many parts of modern vehicles are made of plastic or other materials that do not conduct electricity. You must connect the black wire to a metal part that is not insulated from the vehicle's frame by one of these non conducting parts.
3.Connect the speaker wiring harness(es) (not included) to the speakers in your vehicle as shown in Faxback Doc. # 46863, Fig. A.
If the speaker wires already exist, you can splice the 5 pin connector for the supplied wiring harness(es) onto the existing speaker wires. These connectors make installation easier and make removal of the equalizer/booster (for service or maintenance) easier.
CAUTION: If you use existing speaker wiring or if you run new wires, be sure that chassis ground is not used for any speaker connection. There must be a separate insulated wire for each speaker connection (+ and
4.Plug the speaker's wiring harness(es) into the equalizer/booster. Be sure to connect front and rear speakers as marked.
5.Connect the larger red (power) wire with
Speaker Tips
Your speakers should be capable of handling 40 watts per pair. RadioShack auto sound speakers are normally sold and rated by pairs.
With a 4 speaker system, you can use 4- or
Connecting the Equalizer/Booster to Your Existing Auto Sound System (See Faxback Doc. # 46863, Fig. B)
