BCZ2650S/T/SS

9. Maintenance

Maintenance, replacement, or repair of the emission control device and systems may be performed by any non-road engine repair establishment or individual.

MAINTENANCE CHART

 

 

 

 

every

every

every

 

 

 

 

 

25

50

100

 

 

system/compornent

procedure

before

hours

hours

hours

note

 

 

 

use

after

after

after

 

 

fuel leaks, fuel spillage

wipe out

 

 

 

 

 

 

 

 

 

 

 

 

ENGINE

fuel tank, air filter, fuel filter

inspect/clean

 

 

replace, if necessary

 

 

 

 

 

 

 

idle adjusting screw

see ADJUSTING

 

 

 

replace carburetor

IDLING SPEED (p.12)

 

 

 

if necessary

 

 

 

 

 

 

 

 

 

 

 

 

spark plug

clean and readjust

 

 

 

GAP: .025in (0.6~0.7mm)

 

plug gap

 

 

 

replace, if necessary

 

 

 

 

 

 

 

cylinder fins, intake air cooling vent

clean

 

 

 

 

 

 

 

 

 

 

 

 

 

muffler, spark arrester, cylinder exhaust port

clean

 

 

 

 

 

 

 

 

 

 

 

 

 

throttle trigger, stop switch

check operation

 

 

 

 

SHAFT

 

 

 

 

 

 

 

cutting parts

replace if

 

 

 

 

something's wrong

 

 

 

 

 

 

 

 

 

 

cutting attachment guard

make sure to attach

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

angle transmission

grease

 

 

 

 

 

 

 

 

 

 

 

 

 

screws/nuts/bolts

tighten/replace

 

 

not adjusting screws

 

 

 

 

 

 

 

 

MA1

REFILLING TRIMMING LINE (MA1)

1.For replacement line, use a diameter of .095in (2.4mm). The spool is capable for a line upto 20ft (6m) on the 4” head. Avoid using a larger line as it may cut down the trimming performance.

WARNING

For safety reasons, do not use metalreinforced line.

2.Pinch the slotted area on the both sides of the spool housing to unhook the bottom cap.

3.Take out the spool and pull off the old line. Fold new line so that one half line is 4.7in.(12cm) shorter than another half. And then, hook bended end in the slot of the spool.

4.Wind up the line in the correct direction as indicated on the spool.

5.Hook each end of the line in the slot on the edge of the spool, and then put the ends through the eyelets on the housing. Make sure that the spring and the washers are in place.

6.While holding the spool against the housing, pull the line ends to release them from the slot.

7.Line up the slot on the bottom cap with the hook on the housing, press the cap against the housing until it clicks.

US-14

Page 16
Image 16
RedMax BCZ2650SS, BCZ2650T manual Maintenance Chart, MA1 Refilling Trimming Line MA1