5. Set up
Fig. 1
Fig. 2
Fig. 3
NOTE
Hose clamps are not completely tight. Please tighten hose clamps prior to using.
Hose clamps are left loose to extend life of gaskets and fittings.
WARNING
Oil cap gasket before using and lubricate weekly so the gasket will seal properly and prevent chemical leaks.
Oil check valve and maintain breather hole clear of debris. Your failure to oil may can cause the tank to collapse and crack due to vacuum created by pump lubricate with "3 and 1" oil.
■HOW TO ASSEMBLE
Included in the box, please find the following:
1)PUMP HANDLE & PUMP LEVER.
2)SPRAYER (Pump Module installed).
3)HIP SUPPORT. (Packed in tanks)
4)SPARE PARTS (bag with locking pins & washer).
5)AGITATOR (Packed in tanks)
PUMP HANDLE
The pump handle is made of a tubular steel with a plastic grip on one end, and a round tube welded to the opposite side at right angle. The flat bar has a hole 12.5mm (1/2”) in diameter. This hole is located 57mm (2 1/4”) from the round tube. (See figure 1).
PUMP LEVER
The pump lever is made of a 15.2cm (1/2’) solid round steel bar with two bends, one on either side of the bar. (See figure 1).
PUMP MODULE
Pump module is installed in the sprayer. Now proceed to install pump handle and lever.
ASSEMBLY OF PUMP HANDLE PUMP LEVER & PUMP MODULE
Pull sprayer, pump lever, pump handle, spray wand, plastic bag (with washers and pins), etc. out of box. Place parts in front of you. Take the pump lever, there are bends on either side. (See figure 2). Place one Washers through the bar, then push lever through opening on pump, place washer on pump lever and then place hairpin lock and push through.
On the same side where the pump is located, place the round portion of the pump handle through the hole on the base of the sprayer. When it is almost through, place the bent portion of the pump lever through the hole on the flat portion of the handel. Once through, place on one washer and, then the
6
