RedMax EX-BC manual Set up,  13 

6. Set up

SE1

SE2

SE3

(1)

SE4

SE5

■MOUNTING ENGINE (SE1)

1.Push the driveshaft housing toward the clutch housing and rotate it by hand to check that the driveshaft is engaged with the gears.

2.Insert the driveshaft housing into the clutch housing until it bottoms, and align the positioning holes on the clutch housing and the shaft tube and install the screw. When difficult to engage, twist the engine slightly.

3.Fasten the clamp securely with two screws.

IMPORTANT

Tighten the screws gradually by turns.

■CONNECTING THROTTLE WIRE

1. Remove the air cleaner cover.

2. Connect the end of the throttle wire to the joint on the top of the carburetor. (SE2)

■CONNECTING SWITCH WIRES

•Connect the switch wires between the engine and the main unit. Pair the wires of the same color.

■INSTALLING HANDLE (EX-BC, EX-LRT only) (SE3)

• Install the handle to the shaft tube and clamp it at a location that is comfortable to you.

(1) About 19 inches (48cm)

(EX-PS only) (SE4)

•Insert the grip to the shaft tube.

•Fasten the clamps with screws.

(EX-HE only) (SE5)

•Install the J-shaped handle to the shaft tube and clamp at a position best for your job.

SE6 (1)

■JOINT ATTACHMENT (SE6)

•Insert the attachment to the main shaft.

•Tighten the knob bolt securely.

(1) Knob bolt

13 