ASSEMBLY
Fitting the various gutter kit tubes
WARNING: When fitting the gutter kit tubes, the engine must be switched off.
1.Remove tube clamp bolt.
2.Align slot in the blower air outlet with the raised rib on the elbow tube (A) and in- sert tube into outlet.
3.
4.Push the slotted end of the pivot tube (B) over the elbow until the flange (C) bottoms out in the elbow groove (D).
NOTE: Be sure flange snaps into groove.
B
C
D
A
5.Test rotating action of the pivot tube by ro- tating the pivot tube right and left.
6.Assemble extension tubes up to a total of 4, depending on the height of gutter to be cleaned.
7.Thread nozzle onto the last tube. NOTE: Make sure threaded joints (tubes and nozzle) are securely tightened.
8.Align the tube assembly in a vertical position.
9.Thread extension tube assembly onto the end of the pivot tube.
545212851 Rev. 1 1/5/09 | English |
