I.
Bump head for BT2200LDC and BC2200E
■REPLACING TRIMMING LINE
To refill a new trimming line either ;
A : Install the prewound reel #153577 or
B : Rewind the existing reel.
For replacement line, use a diameter of .080
in (2.03 mm). The engine may overheat and
fail if you use a larger line. For safety reason,
do not use metal-reinforced line.
A : REWINDING THE EXISTING SPOOL
• DISASSEMBLING THE HEAD
1.Hold the outer spool with one hand and
unscrew the Bump Knob bolt (counter-
clockwise for BT2200LDC and BC2200E).
Inspect the captured bolt inside the Bump
Knob to make sure it moves freely. Replace
the Bump Knob if it is damaged.
2.Remove the inner reel. Use a clean cloth to
clean the inner reel, the inside of the outer
spool and the center shaft.
3.Inspect the indexing teeth on the inner reel
and outer spool for wear and, if necessary,
deburr or replace the reel and spool.
• WINDING NEW LINE
1.Take 25 ft (7.6 m) of new trimming line,
insert one end through either hole on the
inner reel and put the other end through
another hole. Hold the line where the both
ends are matching and pull it to make the
loop as small as possible.
2.Wind the line in the direction indicated on
the inner reel, in even and tight layers. Be
sure not to overlap the two ends of the line.
3.Insert each end of the line into the holding
slot.
MAINTENANCE
BT2200LDC
BC2200E
9