9. Maintenance
MA7
(5)
(2)(4)
(1)(3)
MA8(1)
(2)
■BLADE (MA7)
•Place the blade between holders (A) and (B) while locking the gear shaft by putting the bar, through the key holes on the holder(A) and the gearcase. Use the socket and the screwdriver to tighten the blade mounting bolt.
(1)Blade mounting nut
(2)Holder (B)
(3)Blade
(4)Holder (A)
(5)Bar
IMPORTANT
• Attention to the direction of the holder (B)
■INTAKE AIR COOLING VENT
WARNING
•Never touch the cylinder, muffler, or spark plugs with your bare hands immediately after stopping the engine. The engine can become very hot when in operation, and doing so could result in severe burns.
•When checking the machine to make sure that it is okay before using it, check the area around the muffler and remove any wood chips or leaves which have attached themselves to the stick edger. Failing to do so could cause the muffler to become overheated, and that this in turn could cause the engine to catch on fire. Always make sure that the muffler is clean and free of wood chips, leaves, and other waste before use.
•Check the intake air cooling vent and the area around the cylinder cooling fins after every 25 hours of use for blockage, and remove any waste which has attached itself to the stick edger. Note that it is necessary to remove the engine cover shown in (MA8) in order to be able to view the upper part of the cylinder.
