HEZ2460S/HEZ3060S
8. Operation
The RedMax stick edgers are designed | ■ STARTING ENGINE | ||
for edging lawn in gardens, parks, |
|
|
|
roadsides and so on. |
| WARNING |
|
Before starting the engine, take the |
|
| |
|
|
| |
operating position and adjust the handle | The cutting head will start rotating | ||
position and the wheel height as | upon the engine starts. | ||
necessary. |
|
|
|
OP1 |
■ADJUSTING WHEEL HEIGHT
1. Loosen the wing nut and change the |
wheel height to obtain desired cutting |
depth. (OP1) |
1.Rest the unit on a flat, firm place. Keep the cutting head off the ground and clear of surrounding objects as it will start rotating upon starting of the engine.
(1) |
(2) |
(3) |
(1)Deep cut
(2)Shallow cut
(3)Wing nut
2.After adjusting the height, tighten the wing nut securely.
OP2 |
OP3 |
2. | Push the primer pump several times |
| until overflown fuel flows out in the |
| clear tube. (OP2) |
3. | Move the choke lever to the closed |
Tightening Torque:
WARNING
•Never adjust wheel height with the engine running.
| (1) |
| (2) |
| (3) |
OP4 |
|
| (3) |
(2) |
|
(1) | (a) |
| |
| (b) |
OP5 |
|
position. (OP3) |
(1)choke lever
(2)close
(3)open
4.Set the stop switch to the "RUN" position. Place the unit on a flat, firm place. Keep the cutting head clear of everything around it. (OP4)
(1)stop switch
(2)RUN
(3)STOP
(a)lockout lever
(b)throttle trigger
5.Firmly grasp (a) and (b) with left hand (OP4), pull the starter knob quickly until engine fires. Release throttle trigger after engine starts. (OP5)
IMPORTANT
•Avoid pulling the rope to its end or returning it by releasing the knob. Such actions can cause starter failures.
6.Move the choke lever downward to open the choke. And restart engine. (OP3)
7.Allow the engine to warm up for several minutes before starting operation.
