HOW TO USE YOUR ACTIVE 350S SHOWER (SUMMARY)
1.Ensure the electricity and water are turned on to the unit.
2.Turn outer knob “A” clockwise to the “Power Select” position of your choice.
The water will flow, and the neon indicator light will glow.
= High Power
= Medium Power
= Cold Shower
3.Turn inner knob “B” a small amount until you reach the desired showering temperature.
Turn
4.When you have finished showering, turn outer knob “A” 
” position. (You have no need to adjust inner knob “B”).
5.Water will continue to flow for approximately 7 seconds before switching off. This reduces the temperature of the water in the tank for the next user.
The neon indicator light will go out.
6.Switch off the electricity supply at the ceiling switch or local isolator.
Notes
∙Wait 20 seconds for the temperature to stabilise after each adjustment.
∙The neon indicates when the heaters are on and, if the shower has been recently used, can take up to 20 seconds to come on.
During this time the water may go from very hot to cold before stabilising.
Also, please note that the neon indicator does not light when the shower is set to the
“
“ cold power setting.
∙The position of inner knob “B” will be approximately the same each time the shower is used, varying only with incoming water temperature or pressure changes
(e.g. you will only need to change from summer to winter).
∙During normal operation, if an overheated water temperature is sensed then the heater will switch off and the neon indicator will go out.
The water will continue to flow and cool down before the heater switches back on again.
IMPORTANT WARNINGS!
DO NOT SWITCH THE APPLIANCE ON IF YOU SUSPECT IT OF BEING FROZEN.
WAIT UNTIL YOU ARE SURE IT HAS THAWED OUT.
DO NOT OPERATE THE APPLIANCE IF WATER LEAKS FROM THE PRESSURE RELIEF VALVE. MAINTENANCE IS REQUIRED BEFORE THE APPLIANCE CAN BE SAFELY USED.
CONSIDERATION SHOULD BE GIVEN TO SUPERVISING THE YOUNG, ELDERLY AND
THE INFIRM WHILST THEY USE THIS APPLIANCE
Leaflet No.
12
