9. While another person holds the Seat Bracket (11) near | 9 |
|
|
|
the Seat Carriage (41), connect the Right Controller |
|
|
| |
|
|
|
| |
Wire (93), which has a tag attached, to the wire on the | Avoid pinching and |
|
| |
Rear Wire Harness (51), which also has a tag | damaging the wires. |
|
| |
attached. Then, connect the Left Controller Wire (98) |
|
|
|
|
to the Rear Wire Harness. Make sure the connectors |
|
|
|
|
on the Controller Wires (93, 98) are positioned side |
|
|
|
|
by side under the plastic cover on the Seat |
|
|
|
|
Bracket. |
|
|
|
|
Attach the Seat Bracket (11) to the Seat Carriage (41) |
|
|
| 77 |
with four M8 x 19mm Button Screws (77) and four M8 |
|
|
| |
|
|
| 55 | |
Split Washers (55). |
|
|
| |
|
|
| Plastic | |
| 11 |
| 98 | |
|
| Cover | ||
|
| 55 | 93 | |
| 77 |
| ||
| 41 |
| ||
|
| 51 | ||
|
|
| ||
10. Identify the Left Pedal (22), which is marked with an | 10 |
|
|
|
“L.” Using an adjustable wrench, firmly tighten the |
|
|
| |
|
|
|
| |
Left Pedal counterclockwise into the Left Crank |
|
|
|
|
Arm (24). Tighten the Right Pedal (not shown) clock- |
|
|
|
|
wise into the Right Crank Arm (not shown). Important: |
|
|
|
|
Tighten both Pedals as firmly as possible. After |
|
|
|
|
using the exercise cycle for one week, retighten | 25 |
|
|
|
the Pedals. | 22 |
|
|
|
|
|
|
| |
Adjust the Left Pedal Strap (25) to the desired posi- |
|
|
|
|
tion, and press the end of the Left Pedal Strap onto |
|
|
|
|
the tab on the Left Pedal (22). Adjust the Right |
|
|
|
|
Pedal Strap (not shown) in the same way. | 24 |
|
|
|
11.Make sure that all parts are properly tightened before you use the exercise cycle. Note: After assembly is completed, some extra parts may be left over. Place a mat beneath the exercise cycle to protect the floor.
7
