2.While another person lifts the rear of the Frame (1), attach the Rear Stabilizer (16) to the Frame with four M8 x 50mm Button Screws (52) and four M8 Split Washers (55).
3. Tighten the Upright Knob (7) into the Frame (1).
2
1
16
55 55
52
52
3
7
1
4.While another person holds the Upright (2) near the Frame (1), use the wire tie in the Upright to pull the Upper and Main Wire Harnesses (42, 43) through the Upright. See the inset drawing. Tie the wire tie to the ends of the Wire Harnesses. Then, pull the other end of the wire tie upward out of the top of the Upright.
Attach the Upright (2) to the Frame (1) with an M10 x 63mm Bolt Set (62). Be careful to avoid pinching the Wire Harnesses (42, 43).
4 | 42 | |
Avoid pinching | ||
and damaging |
| |
the wires | 43 | |
2 |
| |
| Wire Tie | |
62 | 42, 43 | |
1 | ||
| ||
62 |
|
6
