Gas Stoves
U38 Gas Stove
Venting
This heater is a vented appliance and must be connected to a chimney/ fl ue in accordance with the installation codes.
Note: The rear pedestal cover plate is only required when outside air is being used. If using room air for combustion, remove this plate from the back of the pedestal.
For your safety this heater is equipped with a vent safety switch designed to sense incorrect venting and react by shutting down the gas supply. This thermally actuated switch is located within the draft hood and will detect either a blocked chimney or backdraft condition where the chimney flow has reversed. If this switch shuts the unit down, it indicates a drafting problem that must be identified and rectified without delay - the thermally activated switch must never be bypassed or disconnected as a hazardous or deadly condition can result.
Venting Requirements
A four inch diameter vent is required.
Follow all venting manufacturer’s requirements and local building codes. In cold climates, we recommend the use of insulated
Flue Mounting Bracket
Attach the fl ue mounting bracket with the enclosed screw as shown in the diagram.
156
Gas Stoves
Installation into Existing
Wood Stove Flue System
1)Clean existing Chimney system.
2)Run an approved 4" fl ex liner or "B" vent into existing chimney.
Note: See the chimney systems manufacturer for detailed installation instructions.
June 2007 Regency Product Specifications Book