Reliable MSK-8420B instruction manual 20¡«

3.1.6 Connecting the clutch lever to the pedal (Fig.6)

1)The	optimum tilt	angle of pedal A with floor
is approx.30 degree.
2)Adjust the clutch of the motor so that clutch
lever C	and draw bar B	run in line.
3)The	machine balance wheel should rotate coun-

terclockwise for normal sewing when view from opposite side of balance wheel G . The motor is rotated in the same direction. The rotation can be reversed by rever- sing (turn over 180 deg.)the plug of motor.

4)Adjust the tension of V-belt F by moving the

motor vertically. The proper tension of V-belt is a slack of 10-12mm when the belt is depressed at the belt span by finger.

3.1.7	Installing the bobbin winder (Fig.7)
Align pulley B of					bobbin winder with outside of
belt	C	and should		be kept a proper clearance between
them ,		so that	pulley	B could			be	contacted with belt
after the stop			latch thumb			lever	A	depressed, thereby
belt	drives the pulley				B while machine				running. After
check		bobbin	winder		is	in parallel			with belt slit E
of table, fastened by				two		wood screws			D .

3.1.8 Installing the thread spool stand (Fig.8)

Locate thread spool stand at the right front of the table, note that spool rest may not obstruct when machine head is turned backward, then tighten wood screw.

3.2 Preparation

3.2.1 Cleaning the machine

Before delivery, the machine parts are coated with rust preventive grease, whice may be hardened and con- taminated by dust during storage and shipment. The grease must by removed by clean cloth with gasoline.

						6
					m
G				2	m
				1
			0-
F			1
E
D
C
B					30
				20¡«
A
						7
						E
						D
						C
						B
						A
						D
A	B	A	B	A		8

C

-3-