2
IMPORTANT SAFETY INSTRUCTIONS
When using your new iron, basic safety precautions should always be
followed, including the following:
READ ALL INSTRUCTIONS BEFORE USING
1. Use iron only for its intended use.
2. To protect against a risk of electric shock, do not immerse the iron in
water or other liquids.
3. The iron should always be turned to «Off» before plugging or unplug-
ging from an outlet. Never yank the cord to disconnect from the
outlet. Instead, grasp the plug and pull to disconnect.
4. Do not allow the cord to touch hot surfaces. Let the iron cool com-
pletely before putting away. Loop cord loosely around the iron when
storing.
5. It is always recommended to disconnect the iron from the electrical
outlet when filling with water or emptying. It should also be discon-
nected when not in use.
6. Do not operate the iron with a damaged cord or if the iron has been
dropped or damaged. To avoid the risk of an electric shock, do not
disassemble the iron. Take it to a qualified service depot for exami-
nation and repair. Incorrect reassembly can cause a risk of electric
shock when the iron is used.
7. Close supervision is necessary for any appliance being used by or
near children. Do not leave the iron unattended while connected or
on an ironing board.
8. Burns can occur from touching hot metal parts, hot water, or steam.
Use caution when you turn a steam iron upside down – there may
be hot water in the reservoir.
SPECIAL INSTRUCTIONS
1. To avoid a circuit overload, do not operate another high wattage ap-
pliance on the same circuit.
2. If an extension cord is absolutely necessary, a 15-amp cord should
be used. Cords rated for less amperage may overheat. Care should
be taken to arrange the cord so that it cannot be pulled or tripped
over.
SAVE THESE INSTRUCTIONS IN A SAFE PLACE FOR FUTURE REFERENCE
3