Operation
1.Grasp barrel assembly and slide forward rapidly until it stops. Push barrel assembly back into tool to the closed position. This sets piston into firing position.
2.Insert power fastener into muzzle of tool, head end first. Push the fastener until point is even with end of tool.
NOTE:
Failure to start with the lowest power level can result in overdrive condition and will result in damage to tool (See page 13).
3.Select the proper power level of power load strips. Always insert powder strip loads through bottom of handle. Push power load strip in until even with bottom of handle.
90˚
4.Place the muzzle of tool perpendicular to work surface without tilting the tool. Push tool against work surface until sliding action of barrel stops.
14 | 103500 |
