Remington MPT-2000 manual How To Use Cleaning & Maintenance, Inserting the Battery, How to Use

How To Use

Cleaning & Maintenance

All Remington® detail trimmers run on one "AAA" ALKALINE battery.

Inserting the Battery

1.Make sure the trimmer is “OFF” and remove the protective cap.

2.	Hold the upper part	1
	of the unit and gen-
	tly slide the lower
	part off. (Figure 1)
3.	Insert one “AAA”
	ALKALINE battery
		2
	positive end down.
	(Figure 2)

4. Slide bottom part	+
back onto the unit,
making sure the
notch slides over	3
the ON/OFF switch.
(Figure 3)
Use of any batteries
other than alkaline
will negatively affect

the unit’s operating performance. Batteries should not be left

in the unit if the unit is not in use for long periods. To prevent battery corrosion the unit should be kept in a dry environment.

Dead batteries should be removed immedi- ately and disposed of properly. Do not use batteries that have been recharged. The lower voltage in recharged batteries impairs the performance of the cutting unit.

Before Use:

Test a small area on an arm or leg before using your trimmer completely. Discontinue use immediately if any sensitivity or allergic reaction occurs. Do not use on sensitive or irritated skin.

How to Use:

Trimmer removes stray hair anywhere: eyebrows, neckline, face, ears, nose, knees, ankles, arms, and many more.

1.Remove the protective cap and switch the power to ON.

2.Position trimmer gently against skin at edge of area to be trimmed.

3.Move the trimmer either against or with the direction of hair growth. DO NOT apply excessive pressure. Doing so may damage the trimmer head or result in skin injury.

4.For best results, hold your skin taunt with one hand while trimming.

Using Comb Attachment:

1.Use the comb attachment to easily groom your eyebrows to 2 lengths (2 mm or 3 mm).

2.Make sure the trimmer is off before attaching comb.

3.Decide which length setting you want

to use and position the comb attachment so that the side is facing in the same direction as the trimmer blades. Make sure the grooves on the attachment

are aligned with the grooves on the

trimmer head.

4. With the wide 1 opening down, slide

the attachment over the trimmer head. (Figure 1)

5.Before removing the comb attachment, make sure the

trimmer is off. Then simply slide the attachment off the trimmer head.

Your detail trimmer is designed to give you years of comfortable use. To ensure that you get optimal performance from it, follow these simple cleaning and lubrication tips:

Cleaning Your Trimmer

•After each use, brush or blow accumulat- ed hair from the cutting unit.

Cleaning inside the handle

• For a more thorough cleaning, remove hairs from inside the handle.

1.Make sure the trimmer is OFF and push down the lock to release the trimmer head. (Figure 2)

2

2.Remove trimmer head and clean both head and handle tip with brush.

3.Apply a drop of mineral oil or baby oil to the top of the cutting blades.

4.Replace trimmer head and snap into place by pushing the lock back up.

4 5