20
1. Before connecting any parts or cables, make sure that pin 1 on the both sides are correctly
aligned.
2. Do not apply excessive force to the user system interface board while it is connected to the
user system.
3. The dimensions of the recommended mount pad for the IC socket for this user system interface
board are different from those of the MCU.
4. This user system interface board is specifically designed for the HS1650EPH60H emulator.
Do not use this board with any other emulator.
5. When power is not supplied to the Vcc pin on the user system interface board, the emulator
displays ** VCC DOWN. The emulator will not operate correctly.
6. The P1 jumper socket is used for testing. Do not remove the inserted jumper pin.
P1
13
Do not remove the
jumper pin.
SW1
ON
USER OFF
Figure 16 Jumper Socket
7. Do not connect this user system interface board to the user system for the H8SX/1650 group.